Content System overview Connection diagram System Recourses
Connections Hardware Features
Slide 3
Hybrid telephone system with 12 analog PSTNs & 48 ext.
Caller ID service for CO line & SLT Conference, SMDR, LCR, Call
duration control Collect call barring, Mobile extension Other
services for enterprise communications - Alarm detection - External
door phone control - External paging interface, - External music
source interface System overview
Slide 4
General connection diagram
Slide 5
System Resources 1/2 DESCRIPTIONCAPACITY/BOARDTOTAL Time
Slots128 CO Line Ports3/MBU, 3/EMBU, 3/CHB308, 3/CSB316, 8/VOIB,
30/E1HB8 Max. 36 Max Direct Station (DKT, SLT, DSS) Connections
8/MBU, 8/EMBU, 8/CHB308, 16/CSB316, 8/VOIB, 8/E1HB8 Max. 48 Max.
Door2/MBU, 2/EMBU4 LANMBU, VOIB, E1HB83 MODEM Channel1/MODU1
Attendant Positions5/System Intercom LinksNon-Blocking Paging - All
Call - Internal 1 zone 5 zones Station Speed Dial100/station, 24
digits each500 System Speed Dial24 digits each500 Last Number
Redial15 ~ 50(by admin programming)32 digits
Slide 6
System Resources 2/2 DESCRIPTIONCAPACITY/BOARDTOTAL CO Line
Group88 Station Group10 Conference3~15 PartyAll ports are available
Multi-Conference3~15 PartyMax. 3 groups Internal MOH (13 Music
Sources) 1/MBU1 External MOH1/MBU1 External Paging port1/MBU1
External Relay Contact2/MBU, 2/EMBU4 Alarm Input1/MBU1 RS-232C
Port1/MBU1 DTMF/CPT Receiver channels 16 chs/MBU16 chs FSK Receiver
channels16 chs/MBU16 chs PFT Circuit1/MBU, 1/EMBU, 1/CHB308,
1/CSB3164
Slide 7
MBU connectors and LED Available Option: 1. CN2 : E1HB8,
CHB308, CSB316 or SLIB8 2. CN4 : MODU 3. CN5 : VMIU or AAFU 4.
CN14: VOIB 5. CN9 & CN10: CMU50PR or CMU12PR LD1 : System
running indication LD2-4 : S/W task indication SW1 : Default ON
Pole1 : reserved Pole2 : system trace on Pole3 : reserved Pole4 :
system backup SW2 : Backup battery ON for protection Status
LED
Slide 8
System Connections RJ-11 1: N/A 2: DKT-Tip 3: SLT-Tip or CO-Tip
4: SLT-Ring or CO-Ring 5: DKT-Ring 6: N/A CO# : Loop start CO Port
STA# : Hybrid Port DKT# : DKTU Only Port SLT# : SLT Only Port BKSU
EKSU BKSU Only
Slide 9
Connector Pin-out 1/3 NOTEWhen installing DKT or SLT on Hybrid
Ports, (MJ2-2,3,4,5,6,7,8), keep the above pin assignment.
Otherwise the DKT or SLT will not operate normally. MBU (CO)
Connector PIN NumberNOSignal Name RJ111,2N/A 3,4CO-T, CO-R 5,6N/A
MBU (Extension) DKT ONLY CONNECTORPIN NUMBERNOSIGNAL NAME RJ111N/A
2DKT-T 3,4ALARM_Detection 5DKT-R 6N/A MBU (Hybrid) CONNECTORPIN
NUMBERNOSIGNAL NAME RJ111N/A 2DKT-T 3,4SLT-T, SLT-R 5DKT-R
6N/A
Slide 10
Connector Pin-out 2/3 TERMINAL DKT CONNECTORPIN NUMBERNOSIGNAL
NAME RJ111N/A 2RING 3,4Reserved 5TIP 6N/A TERMINAL SLT CONNECTORPIN
NUMBERNOSIGNAL NAME RJ111,2N/A 3,4TIP, RING 5,6N/A
Slide 11
Connector Pin-out 3/3 CN13 Pin Assignment (Relay Contact)
CONNECTOR NOSIGNAL NAME 4 PIN1Relay 1-pin1 2Relay 1-pin2 3Relay
2-pin1 4Relay 2-pin2 MJ3 Pin Assignment (LAN) ConnectorPin
NumberNOSIGNAL NAMEFUNCTION RJ454,5,7,8RESERVED 1TX+Transmit Data
2TX-Transmit Data 3RX-Receive Data 6RX+Receive Data
Slide 12
Terminal/SLT Cabling Distance
Slide 13
Expansion Card CHB308 External. Provides 3 circuits Loop start
CO line interface. DTMF or pulse signaling to line Loop current
detection FSK & DTMF CID detection. Call progress tone
detections Internal. Provides 8 digital Stations or 8 SLT station
circuits. FSK & DTMF CID detection and Generator. +36V Power
Circuit for SLT feeding SLT feeding Current is 20mA at 900ohm loop
impedance. CO Line and Hybrid Board (3 CO + 8 HYB)
Slide 14
Expansion Card CSB 316 CO Line and SLT Board (3 CO + 16 SLT)
External. Provides 3 circuits Loop start CO line interface. DTMF or
pulse signaling to line Loop current detection FSK & DTMF CID
detection. Call progress tone detections. Internal. Provides 16 SLT
station circuits. FSK & DTMF CID detection and Generator. +36V
Power Circuit for SLT feeding SLT feeding Current is 20mA at 900ohm
loop impedance.
Slide 15
Expansion Card SLIB 8 SLT Board (8 SLTs) Internal. Provides 8
SLT station circuits. FSK & DTMF CID detection and Generator.
+36V Power Circuit for SLT feeding SLT feeding Current is 20mA at
900ohm loop impedance.
Slide 16
Expansion Card E1HB8 E1 Digital trunk & 8 Hybrid CN5 on the
MBU, but not on the EMBU E1 digital trunk: maximum 30 CO lines at
the same time 8 Hybrid ports that provide DKT or SLT connection
2.048Mbps E1 line as CAS(Channel Associated Signaling) HDB3 CODE
DID, DOD, and TIE according to each countrys specifications Pulse
dialing, DTMF dialing, and MFC-R2 signaling(30 channels at the same
time) SLU8(Single Line Interface Unit: 8 ports CN6, CN7 on the
E1HB8 +36V power circuit for SLT feeding Single Line Interface
circuit: 8 EA
Slide 17
Add on board MODU MODEM function board MODU provides analogue
modem connection. MODU should be installed on the CN4 Supports
Bell, ITU-T, V.34, V.32BIS, V.90 Protocol 300bps up to 33Kbps speed
rate Automatic rate negotiation Modem function board
Slide 18
Add on board VMIU VMIU provides 4 channel Record/Play VMIU
provides Time & System prompt All message are saved in Flash
memory Max record time - Prompt : 8 Min. - System greeting : 24 Min
- User record time : 99 Min Max. Number of User Voice Message:
800ea Note : User Greeting does not lost by system power off or
reset Note : User Greeting does not lost by system power off or
reset because of this message is stored in FLASH memory because of
this message is stored in FLASH memory Voice Mail Interface
Unit
Slide 19
Add on board AAFU Auto Attendant Function Unit AAFU provides 4
channel Record/Play AAFU provides Time & System prompt All
message are saved in Flash memory Max record time - Prompt : 8 Min.
- System greeting : 24 Min - User record time : 9 Min Max. Number
of User Voice Message: 800ea Note : User Greeting does not lost by
system power off or reset Note : User Greeting does not lost by
system power off or reset because of this message is stored in
FLASH memory because of this message is stored in FLASH memory
Slide 20
Add on board VOIB & VOIU Voice over Internet Protocol
Interface board ItemSpecification LAN Interface10 / 100 Base-T
Ethernet(IEEE 802.3) Speed10 Mbps (Auto-Negotiation) DuplexHalf
Duplex or Full Duplex(Auto-Negotiation) VoIP ProtocolH.323 Revision
2 Voice CompressionG.711/G.726/G729/G.723.1 Voice/Fax SwitchingT.38
Echo cancellationG.165 VOIB can be installed on the basic MBU
Provides the Ethernet interface for S/W applications and VoIP
features. Optional VoIP daughter board.(VOIU) Maximum Capacity: 8
channels -VOIB provides four(4) VoIP channels. -VOIU provides
four(4) VoIP channels.
Slide 21
Add on board CMP50PR & CMU12PR Call Metering & Polarity
Reversal Detection unit 50Hz and 12Hz CMU50PR (Call Metering-50 Hz
& Polarity Reversal Detection unit) Provides 3 channels Call
Metering detection for 50Hz Provides 3 channels of Polarity
Reversal Detection It can be installed on the MBU, EMBU, CHB308 or
CSB316 CMU12PR(Call Metering-12KHz & Polarity Reversal
Detection unit) Provides 3 channels Call Metering detection for 12
KHz or 16Khz Provides 3 channels of Polarity Reversal It can be
installed on the MBU, EMBU, CHB308 or CSB316
Slide 22
Proprietary Terminals MODELDESCRIPTION LDP-7224D3 Line LCD
display, 24 Flexible Button,3 Soft keys, Navigation key LDP-7208D2
Line LCD Display, 8 Flexible Button LDP-7248DSS48 Button DSS
Console LDP-DPBDoor Phone Box LDP-7248DSSLDP-Door phone LDP-7224D
LDP-7208D Not Compatible with OptiCon IP and GDK Systems.
Slide 23
IP Terminals MODELDESCRIPTION LIP-7024LD3 Line LCD display, 24
Flexible Button,3 Soft keys, Navigation key, Dual
LED,Calender,Scheduler LIP-7024D3 Line LCD display, 24 Flexible
Button,3 Soft keys, Navigation key, Dual LED LIP-7016D3 Line LCD
display, 16 Flexible Button,3 Soft keys, Navigation key, Dual LED
LIP-7008D2 Line LCD Display, 8 Flexible Button
LIP-7024DLIP-7016DLIP-7024LDLIP-7008D
Slide 24
Maintenance PSTN Dial-up Connection Off-site (Remote)
Maintenance Data Network In-site maintenance Digital Terminal Admin
Maintenance Console On-site & Off site maintenance through
RS-232C, Ethernet, Modem On line PC Admin : DB up/download,
Diagnostics, S/W upgrade, PC Admin Off line PC Admin (PC Admin Pro)
Speed Editor for system speed dial User level admin program
adjustable level program
Slide 25
Voice Mail / Auto Attendant Voice Mail SMS Notification to
virtual extension (mobile extension) 4 ch. / Max. 100 min recording
time/ 25 min greeting / 800 user message recording Max. 100 system
greetings / Max. 25 min Optional Voice Mail and Auto-Attendant
Auto-Attendant : 4 channels / 10 min recording / 25 min system
greeting
Slide 26
Networking SIP / H.323 proxy registration Business models for
SIP operator / Nortel IP platform ARIA IP 60 Voice Networking