Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 1/6
aFRC616 + Micro SD Card dual set solution
Data sheet
APLUS INTEGRATED CIRCUITS INC. Address:
3 F-10, No. 32, Sec. 1, Chenggung Rd., Taipei, Taiwan 115, R.O.C.
TEL:
886-2-2782-9266
FAX:
886-2-2782-9255
WEBSITE:
http://www.aplusinc.com.tw
Technology E-mail:
Sales E-mail:
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 2/6
FEATURES
164 minutes in 12KHz & 8-bits playback sample rate.
3V ~ 5V single power supply.
20~25 uA low standby current.
Two playback sample rates are allocated :12KHz and 24KHz.
8-bits/16-bits resolution DAC/PWM voice output.
Up to 64 voice groups to store wav files.
3 control modes – SBT mode, MP3 mode and SPI mode.
8 levels of volume control.
10,000 insertion/removal cycles
DESCRIPTION
aFRC616 is a 16-bits audio processor embedded with 8bits-MCU and 16bits-DSP
engine. It can store 164 minutes of data on micro sd card with 1G bits external
memory in 12KHz, 8-bits sample rate.
User can select play back with12 KHz or 24 KHz sample rate, 8-bits/16-bits resolution
and PWM/DAC voice output .
Circuit Block Diagram
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 3/6
Audio/Voice supports the following voice formats.
ULAW8-12K PCM16-12K PCM16-24K
Micro SD – 1Gb 164min. 82min. 41min.
Source file 8bit-12k or higher Mono WAV file
Note : The SD card will be reformatted once it is inserted to the PC
VOICE OUTPUT
The aFRC616 supports PWM and DAC voice output. The PWM mode uses VOUT1 and
VOUT2 pin to drive speaker directly without external components.
The DAC mode uses VOUT2 pin to output current signal. User can use the signal to drive
audio amplifier or mix with other components in their applications to provide higher volume.
The following figure shows the circuit for different output methods: PWM, DAC-BJT,
DAC-AMP.
SBT MODE
. SBT Key (PX1) : Play the voice in sequence.
. Lock Key (PX2) : Keep playing in loop the voice selected by PX1.
. Volume Control (PD2) (vol-) : 8 Levels of volume control (Default :Maximum volume)
. Support enable/disable POWER ON LOOP
. Support enable/disable SBT LOOP
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 4/6
Typical Application Circuit : (Voice output : DAC-AMP)
*Note: 1. LDO input voltage range minimal is 3V~ 5V. LDO output current range minimal is 200mA.
2. PMOS Gate-Source voltage (VGS) minimal: ±10V, On-State Drain Current (Id(on)) minimal is
200mA.
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 5/6
SYSTEM STATE : SBT Mode
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 6/6
MP3 MODE
a. Play/Pause key (PX1): Play or Pause all voice groups contents.
b. Next key (PX2) : Play all the contents of the next voice groups.
c. Volume Control (PD1)(vol+) : Volume up key,
d. Volume Control (PD2)(vol-) : Volume down key
Note : 8 Levels of volume control (Default :Maximum volume)
Typical Application Circuit : (Voice output : PWM)
*Note: 1. LDO input voltage range minimal is 3V~ 5V. LDO output current range minimal is 200mA.
2. PMOS Gate-Source voltage (VGS) minimal: ±10V, On-State Drain Current (Id(on)) minimal
is 200mA.
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 7/6
SYSTEM STATE : MP3 Mode
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 8/6
SPI MODE
This SPI mode is specially designed for simple CPU interface. The aFRC616-Micro SD is
controlled by command sent from the host CPU. The pins PC3, PC2 and PC0 are used to
input command of data type word to the chip while the PX0 is the output pin from the chip
to the host CPU for feedback response.
a. /CS (PC2): (Chip Select) to initiate the input command.
b. SCK (PC0): (Serial Clock) to clock-in the command at rising edge.
c. SDI (PC3): (Data-In) to input the command bits.
d. SDO (PC1): (Data-Out) NC
e. /BUSY (PX0): (Busy Signal) to feedback response.
Note : 8 Levels of volume control (Default :Maximum volume)
Typical Application Circuit : (Voice output : DAC)
Note: 1. LDO input voltage range minimal is 3V~ 5V. LDO output current range minimal is 200mA.
2. PMOS Gate-Source voltage (VGS) minimal: ±10V, On-State Drain Current (Id(on)) minimal
is 200mA.
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 9/6
SYSTEM STATE : SPI Mode
Serial Command
Each input command contains 16-bit data. The following list shows the command format and
the summary of the available commands:
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 10/6
Command List
Play: The Play command is used to play voice.
The Play command is 0101 0000 00-XXXXXX in binary, from bit-15 to bit-0 where D5 to D0
are the 6 bits (0~63) assigned to the group address.
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 11/6
VOL Ctrl: The Volume control command is used to set volume level.
The VOL Ctrl command is 0101 0110 0000 0-XXX in binary, from bit-15 to bit-0 where D2
to D0 are the 3 bits (0~7) to set the volume level (max: 7, min: 0).
Sleep: The Sleep command is used to power-down the chip.
The Sleep command is 0111 0011 0000 0000 in binary, from bit-15 to bit-0. When the Sleep
command is executed, the chip enters in standby mode
Wake Up: The Wake Up command is used to power-up the chip.
The Wake Up command is 0111 0111 0000 0000 in binary, from bit-15 to bit-0.
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 12/6
AC CHARACTERISTICS
Timing Waveform
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 13/6
DC CHARACTERISTICS : aFRC616-SOP28
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 14/6
PACKAGE INFORMATION:
28Pin 300mil SOP Package
INTEGRATED CIRCUITS INC. aFRC616 - Micro SD
Ver. 1.21 15/6
HISTORY
Ver. 1.0 (2017/06/01)
- Original version data sheet for aFRC616-Micro SD.
Ver. 1.1 (2017/07/07)
- Add SPI Mode for aFRC616-Micro SD.
Ver. 1.2 (2017/07/12)
- Add SBT mode & MP3 mode system state diagram.