Installation InstructionsRX-1 TRUNK SADDLEBAG, -Part No.
SMA-8FA73-20-00
2. INSTALLATION:
ISSMA8FA7320/R4
Parts & Accessories
a)
b)
c)
d)
e)
a) NEVER OVERLOAD the trunk saddle. The LOAD LIMIT is 5 lbs.
maximum per saddlebag and trunk bag.b) DO NOT carry sharp, pointed
or heavy objects in the saddlebags.c) Distribute the load evenly
between the saddlebags, packing the heaviest items in the bottom of
the saddlebags.d) Use cinch straps to tighten load - Loose objects
may be damaged or do damage to the bag.
1-8-07
3. SADDLEBAG LOADING CONSIDERATIONS:
Thread the buckles as seen in Fig. A.
Place bags over the rear seat hump, making sure that they are an
equal distance from the running boards oneach side, and square on
the machine.
Pull the front strap forward and down against the tunnel, mark
the location where the center of the cam bucklewill fall. This
should be about 1.5" from where the webbing attaches to the
bag.
Using a 3/16" drill bit, drill the tunnel and install the cam
buckle with the provided rivets. (See Fig. B)
Lace the rear straps around the back bumper connect buckles. For
RX-1 Mountain sleds feed the rear strapsunderneath the exhaust
covers. Place the webbing loop in the center of the tunnel
extension directly behindthe coolant hose cover. Using a 3/16”
drill bit, drill and pop rivet the strap to the tunnel extension.
Feed thetwo straps through the webbing loop connect buckles and
cinch tight. (See Fig. C) Note: Excess webbingmay be trimmed from
the strap. Simply cut the webbing and burn the edge to prevent
fraying.
Use a sponge or cloth and clean water. Do not use detergents or
harsh chemicals.4. CARE & CLEANING:
5. CUSTOMER SERVICE: See your YAMAHA dealer.
1. PARTS LIST:
Please read and understand the instructions completely before
installation to avoid any possible injury to yourselfor damage to
the accessory or your snowmobile.DEALER: These instructions contain
important information for future reference and must be given to the
customer.
Study the illustration thoroughly before proceeding.
INSTRUCTION SHEETYAMAHA TRUNK SADDLEBAGSPOP RIVETSCAM BUCKLE
ASSEMBLIES1" SR-1 SIDE RELEASE BUCKLEWEBBING LOOP
123456
PAPERBALLISTIC NYLONZINC OXIDEACETAL PLASTICACETAL
PLASTICPOLYESTER
11 SET5411
ITEM PART NAME DESCRIPTION QTY.
(Enlarged view of cam buckle/rivet)
Fig. BUp
(Enlarged view of cam buckle)
pull to tighten
attachedto bag
Fig. A
(Enlarged view of SR-1 buckle)
Fig. C
FOR OTHER APPLICATIONS: Pull the rear strap forward and down
against the tunnel.Drill and pop rivet the cam buckle to the
tunnel. Remove excess buckle if so desired usingside cutters. Cut
and sear excess webbing.
