Upload
vantruc
View
217
Download
0
Embed Size (px)
Citation preview
D
E
F
G
H
D)With a couple of inches of back liner pulled and foldedunder align one edge and center film on screen Allowfilm to contact screen when correctly positioned
E) Apply light pressure to top side of film to seal If youobserve an air bubble it is OK to continue as they can bepushed out later (see step G) as long as the alignmentis correct
F) Slowly pull a small amount of backing at a time and allowthe film to lay in place without tension on the film asthat causes bubbles Allow it to roll into place
IMPORTANT If you have persistent dust or bubbles during installation thatrsquos OK as long as the alignment is correct Dust andor bubbles can be left in place to fix later if needed Just be sure to finish installing the film to completely seal it to the screen
As you near the end remove the back liner completely and allow the film to slowly lay in place
G)With the provided squeegee or a credit card with the included cloth around it push any air bubbles to the nearest edge If you observe an air bubble with a dot in the center this is dust or lint If your top liner is still in place you can use a marker to circle the debris location To remove a speck carefully lift the nearest corner and use the enclosed tacky tape TIP Debris normally sticks to the silicone Gift wrapping tape loosely wrapped around one or more fingers (sticky side out) also works well to remove debris specks from the silicone backing and screen surface
H) Most films have an additional front protective liner(identified with a 2 label) carefully remove and discard this liner
Apply light pressure around the edges to seal Clean and maintain with regular screen cleaner
Congratulations The installation is now complete
Please contact us if you have any issues We are here to helpFor additional information and helpful tips on film application check the FAQs
httpwwwphotodoncomFAQ-Screen-Protectorshtml
Visit Photodoncom for other Professional Screen Care ProductsPhone 8473771185 M-F 9-5 EST E-mail salesphotodoncom
Photodon LLC Traverse City Michigan USA
Installation Instructions Please read throughALL of the instructionsBEFORE YOU BEGIN
For more help check out our installation video
httpwwwphotodoncomVideoshtml
A
B
C
Successful installation notes bull
bull
AVOID BUBBLES Install film to a clean dust-free screen in a clean environment Thoroughly clean the installation area Vacuum and wipe hard surfacesbull Avoid wearing linty clothesbull Apply with the screen off and coolbull If possible lay the device flat to make installation easier bull A second person may be helpful for films 30 or largerbull Optimum temperature for installation above 60deg F (16deg C)
A test film is in the outside packet Do Not Unpackage your order unless you are satisfied with the results
A) Apply the enclosed test film (remove liner(s) asindicated) to get a feel for how the film works and to seeif the effect is agreeable
If satisfied with test film results gently open your purchased film (do not remove any liners yet) Inspect it for damage and ensure that it is a proper fit for your screen Note proper alignment on all edges Blemishes and bubbling may occur during shipping this normally does not affect the film installation result
DO NOT RUSH THIS NEXT STEP Dust between the film and the screen creates bubbles that will need to be dealt with later
B) 1 Clean the film with a clean lint-free screen cloth dampened with screen cleaner or staticide to remove
fine dust particles and reduce static electricity2 Use the installation supplies provided with your orderto clean the device screen
3 Use a vacuum with a clean brush attachment (ifavailable) to help remove any remaining dust from thescreen and surrounding area Otherwise use the tackytape to gently remove any remaining lint or dust fromyour screen
C) InstallationUse 1 tab to begin removal of the back liner Do not fully remove see next step
IMPORTANT As you remove the back protective liner DO NOT TOUCH the filmrsquos adhesive backing as fingerprints can transfer and remain on the film