Upload
samuel-barrett
View
224
Download
7
Tags:
Embed Size (px)
Citation preview
Install InstructionsAugust 1, 2008
Standard Knock-out plates need to be removed from the
machine
You will receive a Template in your
User Manual for all Knock-out Plates
• For the four small holes – use a 7/32 drill bit• For the two larger holes – use a 3/8 drill bit
• Carefully drill holes on the appropriate Knock-out plate to the exact dimensions of our template.
• Reinstall Knock-out plate on the machine before adding Microtronic Msmart hardware.
Finished Product
This is what you receivein your Msmart Kit
Reader
Velcro
ReaderAntenna or Head
MDB Connector Cable
Cable from “Reader Head plug” to “Head”
Cable from “ANT” on Reader to plug on “Head”
Plug in details
White plug from “Head” to “HEAD” port on Reader
Cable with Gold plug on both ends for “ANT” port on Head
MDB Cable will connect with Black end into “VMC” port on Reader
White MDB plugs go from the Vending Machine and Validator or Coin Mech
Before Installation
• Make sure all power is turned off to the Vending Machine
• Have pre-drilled Knock-out Plate ready• You will need a Phillips Head
Screwdriver and an 11/32” Nut Driver• On National Vending machines you
may also need a ¼” Nut Driver for easier removal of the Knock-out Plate
Connection to the Vending Machine
Reader mounted with Velcro provided in kit
Make sure cables are not in the way by strapping them together.
Cables from Reader to Head
Predrilled Knock-out Plate installed
Head is mounted with 4 screws provided in kit
Green Light is “Ready to Go”
Vending Machines with Keypad
• Press “Machine Config”• Arrow down to “Card Reader”• Select “MDB CARD”• Arrow down to “Revalue”• Select “ON” if you want the
machine to also Load Value to the Microtronic Media or “OFF” if not.
• Press “Exit”• You should then have a
“Green” light and you are again . . .
• READY TO GO!