Upload
others
View
12
Download
0
Embed Size (px)
Citation preview
DAYTIME RUNNING LIGHTS
LED
DTRL600S
Inclusions
Wiring Instructions DTRL Wiring Instructions
LED lights
Fasteners
Rubber support base
x x x x x x x x x x x x x x x x x x+12/24V (Acc)
12/24V (Ground)
These lights have 3 separate input wires for multiple applications. They can be used as Indicators, parkers or reverse lights.
+12/24V (Acc)
12/24V (Ground)+12/24V (Acc)
+
87. Normally Open87a. Normally Closed30. Common Terminal85. (Negative) Coil86. (Positive) Coil
30
For DTRL usage a relay is required
87
85 87a 86
Relay
Headlight
4
Wiring Instructions cont...
1. To mount DTRL’s, use supplied rubber support base & mounting hardware.2. Connect the supplied wiring harness.3. 3 input wires +12V/24 DC ignition or accessory wire
4. Wire with (_ _ _ _ symbol) connect to 87a of relay 5. Connect headlight to 86 of relay6. Once connected, turn on to ignition, DTRL’s will turn on. Turn on parker lights and DTRL’s turn o�
Notes: Some vehicles including CANBUS may require an additional relay to be installed betweenthe DTRL and parking light connection. This is to �x �ickering problems with the LED’s. 1. To mount DTRL’s, use supplied rubber support base & mounting hardware.
2. Connect the supplied wiring harness.3. 3 input wires +12V/24 DC ignition or accessory wire4. Wire with (_ _ _ _ symbol) to car ground (chassis) of vehicle
5
+12V/24 DC
Installation
1. Use DTRL rubber support base as a template for marking holes required for attachment
2. Drill holes into bumper
3. Line up DTRL to pre-drilled holes and secure with screws or bolts provided
For mounting userubber base as
the template
Drill centrehole for wiring