ICE MAKER & DISPENSER

IM-166

Instruction Manual

Thank you for choosing our electric appliance . Read this Instruction Manual carefully before operation . Please keep it in a safe place and refer to it when necessary.

Description

　　　SpecificationVolt / Frequency 230V ~ 50Hz

Ice making current 1.1AIce Making Capability 12kg/24hRated Total Power 700WHeating Power 550WIce Making/Cold water Power 150W

Ambient Humidity ≤90％

Hot Water 3.5L/hour, 80℃Cold Water 2L/hour, <10℃

Product Size W*D*H（mm） 440*330*525

Climate Class T Ice making with cooling water current 1.5A Ice Storage 1.0 kg Hot water tank capacity 1L Tank for cold water: 2L

Ambient Temperature 10－43℃

Refrigerant/Quantity R134a

FunctionInstant making ice

Ice bin full alarmAdd water alarmHot Water DispenserCold Water DispenserWarhead shaped ice12pcs of ice cube in per cycleTimerLCD display

B efore / F irst U se of Y our Ice Maker 1. Don't incline the machine over 45°c at any time. The Ice Maker must be horizontal. 2. The Ice Maker must be on a properly leveled surface. Make sure the Ice Maker is placed at least 150mm away from the wall to the back and sides for adequate ventilation. Please do not place the Ice Maker near a source of direct heat or strong magnetism. 3. For first use, please purge both Hot and Cold water taps before switching your unit ON.4. Water should be drained a few times to remove any smell or taste due to manufacturing process. This must be carried out until you reach the desired standard.

Control Panel Operation

Indicator Area

Warning, low water indicator

Time Display,first two digital is for hour,last two is for minute

Ice level indicator

Clock display Setting the timer to turn “On” the Ice Making or Hot Water

Setting the timer to turn “Off” the Ice Making or Stop making Hot Water Informs you that you are now setting the time for ice making Informs you that you are now setting the time for hot water

Once illuminated, it means the water is Heated up to temperature and ready for use

Child Lock Display is on or off, if indicator is “On”, this means unit is Locked

Means the machine is on Ice Making function

Cold water function, once illuminated, water Cold and ready for use

Button Area

press this button to Start or Stop ice making and set time

press this button to Start or Stop making hot water

press this button to Start or Stop making cold water

press this button to set time or active the child lock

press this button to dispense cold water

press this button to dispense hot water

Note: Please do not touch hot water as the temperature may be too high

press this button to power on the machine

Operating InstructionStep 1: Add waterIf bottled water is used, remove the paper seal and plastic, then tip bottle onto the cleaver seat, water will release into the machine automatically.if pipe is used,

Note: Inlet water pressure should be within 0.1-0.4Mpa

Step 2: Connect to power and press to start the machine.

Step 3: Press the right buttons to start the function you want.

Note：After the water is filled, press first，then till water comes out from the water

faucet， lastly press for making hot water so as to avoid the heater going into automatic

protection

Note: For the first three cycles, the ice may be small and irregular in size. If no water is pumped up to the water tray over two cycles, then please open the drain cap and let several drops water runs out.

Step 4: Getting hot /cold water / ice

4.1 Hot water: Press button then to get hot water.

4.2 Cold water: Press button directly

4.3 Ice: Pull the ice drawer out and take ice with the ice scoop

Step 5: Set timer:You can set the clock to automatically turn on and turn off time via following steps:

5.1 Setting The Clock:

Long press on the button till the figures at the indicator area is Illuminated then press the

button to change the hour,and again and ,to change the minute,after the right time

is set,the time will flash for 5seconds,then locate.

5.2. Setting The Timer for The Ice Making Function:

A1, Long press on the button till the clock is illuminated,

A2. then short presses on the button till the indicator and appear,

A3. when the first two digits are illuminated,press the button to change the hour,

A4,after it is set,with a short push on the button again,the last two digits will illuminate,press

the button again to change the minutes.

A5. When you are finished and the figures are not illuminated, long press on the button till

indicator is on.

5.3. Unsetting The Timer for The Ice Maker Function:

B1, Long press on the button till the clock is illuminated,

B2. then short press on the button till the indicator and appear,

B3. when the first two digits are illuminated,press the button to change the hour,

B4,after it is set,with a short push on the button again,the last two digits will illuminate,press

the button again to change the minute.

B5. After the setting is finished and the figures are not illuminated, long press on the button

till indicator is on.

5.4. Setting The Timer for The Hot Water Function,

C1.Long press on the button till the clock is illuminated.

C2.Short press on the button until the indicator HOT and appear.

C3.When the first two digits are illuminated,press the button to change the hour.

C4. When it is set,short push the button again,the last two digits will shine,press the

button again to change the minute.

C5. After the settings are finished and the figures stop are not illuminated,long press on the

button till indicator is on

5.5 Unsetting The Timer for The Hot Water Function:

D1, Long press on the button till the clock is illuminated,

D2. Short press on the button till the indicator and appear,

D3. When the first two digits are illuminated,press the button to change the hour,

D4, After it is set,short push on the button again,the last two digits illuminate,press the

button again to change the minute.

D5. After the settings are finished and the figures stop shinning, long press on the button till

indicator is on.

5.6 Time setting for turning hot water function on and off,follow step A1,A2,A3,A4,B2,B3,B4,C1,C2,C3,C4,D1,D2,D3,D4 after the setting is finished and the

figures stop shinning , long press on button till indicator and are on.

Step 6: Drain waterTake off the cap at back of the units to drain the water, Blue for cold water, Red for hot water

Caring & Maintance1. Clean the ice collecting tray, ice shovel and evaporator frequently. Please unplug the unit and remove ice cubes before cleaning or maintenance. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice Maker. Do not spray Ice Maker with chemicals or diluted agents such as acids, gasoline or oil. Dry thoroughly before using. 2. Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. 3. Do not use mechanical devices to accelerate the defrosting process, other than those recommended by the manufacturer.4. To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours. 5. If the compressor stops for any reason such as water shortage, too much Ice, power off, etc. Do not start the system right away, wait 3 minutes, and then re-start the Ice maker. 6. Always change with fresh water before starting ice production at initial installation or after long shut-off periods. 7. If the temperature is low, the ice may get blocked, if so, unplug the machine and leave it for 30minutes, after the ice has melted, you can restart the machine.8.At night or when people are not around, please turn off the power. Please do not try to stop or start the machine by plugging in or out by the socket.9. Ensure the mains voltage corresponds to the rating on the rating plate it must have reliable grounding 10. Please don’t touch the evaporator when it is making ice11. This machine is not suitable for outdoor use.12. When the compressor is not working, please do not restart it right away, wait 3 minutes then restart.

13. Warning: after draining the water, please make sure the drain cap is covered.

Trouble Shooting

Problem Possible Cause Suggested SolutionsThe compressor works abnormally with a Buzzing noise

The voltage is too low Stop the Icemaker and do not restart until the voltage is normal.

Ice connected each other and can’t drop down

1.Evaporator is too low2.Ices from prior cycles is left at the water tray3. Electromagnetic valve doesn’t

work and then some ice doesn't drop down

Cut off the power right away,restart the unit unit all the ice in the water tray melt down1. Shift the evaporator3. Replace the magnetic valve

Unit work well,but no ice made

1. Temperature too high or ventilation not enough2. Fan doesn’t work3. Refrigerant leaks or cooling system is blocked

1. Change machine to other place and restart2. Change Fan3. Call service

No water drops from water tape

1. No water in the machine.2.Input mouth of the cleaver seat is blocked3. Inlet pipe is blocked

1. Add water2. Move the material which blocks the mouth/pipe

Hot water not so hot,Cool water not so cool

1. Too much hot/cool water is used2. No power3. Time for cooling/heating is not Enough.

1.Wait for a while to get water2. Make sure power is provided3.Cooling in first time, wait 2hours to get water

Leakage 1.The buoy is blocked2.Inner water pipe is broken3.Non-pressure valve is broken down

1.Take off the bottled water right away,and drain all the water completely,then put back the bottled water2.Replace water pipe3.Replace non-pressure valve

No water from cooling tape

Pump is broken down Replace the pump

Much noise from hot tank

The tank is too dirtyClean it with 5％ edible citric

acid to clean it

Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems

or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

WARNING

If the supply cord is damaged; it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazardFill only with potable water. It is normal for the compressor and condenser surface to reach temperatures between 70°C and 90°C during operation and surrounding areas may be very hot. Due to fast freezing, ice cubes may appear “Cloudy”. This is trapped air in the water and it will not affect quality or taste of ice. Check that the mains voltage corresponds to the rating of the appliance before operatingPlace on a flat stable surface for use.Do not use near a bath or swimming pool Unplug from socket outlet when not in useTo protect against electric shock, do not immerse cord or plug in water or any other liquidThe use of accessory attachments not recommended by the appliance manufacturer, may cause injuryDo not allow cord to overhang the counter top where it can be easily pulled by childrenDo not use this appliance for anything else other than its intended useDo not leave the appliance unattended when in useTo remove plug from outlet, do not pull on supply cord. Grasp plug firmly and pull to removeNo liability can be accepted for any damage caused by non compliance with these instructions or any other improper use or mishandlingThis appliance can be used by children aged from 8years and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision

If the supply cord is damaged in any way, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.R-134a is a fluorinated greenhouse gas covered by the Kyoto Protocol,its global warming potential is

1300.Please keep the unit well.