-
IEEE SA SCC211547.1 Full Revision PAR Development Meeting
SCC21 Meeting October 1-2, 2014Piscataway, New Jersey
Dick DeBlasio, IEEE SCC21 ChairTom Basso, IEEE SCC21 Vice
Chair
-
IEEE SA SCC21 1547.1 Full Revision Workshop AGENDA: DAY
ONEOctober 1, 20148:00 am to 8:30 amSign In 8:30 am to 9:00 am
Welcome and Meeting attendees Introductions (around the room) Dick
DeBlasio, SCC21 Chair; Justin Caso, IEEE HQ9:00 am to 9:30 amAgenda
and Workshop Expectations, Dick DeBlasio IEEE standards: protocols
and use, Justin Caso, IEEE SA; Tom Basso, SCC21 Vice Chair 9:30 am
to 10:00 amSCC21 Series of Standards - Tom Basso10:00 am to 10:30
pmBreak10:30 am to 10:45 pmP1547.1 Full Revision Project: Proposed
PAR Initial Straw Man TITLE, SCOPE and PURPOSE - Dick DeBlasio
10:45 am to 12:00 pmIndustry Suggestions (5-10 minute overviews),
Tom Basso; All 12:00 pm to 1:00 pmLunch provided 1:00 pm to 3:00
pmOpen Discussion Industry Suggestions for TITLE, SCOPE and PURPOSE
- Tom Basso3:00 pm to 3:30 pmBreak3:30 pm to 4:30 pmOpen Discussion
Formulate into Revised Draft Straw Man TITLE/SCOPE/PURPOSETom Basso
and Dick DeBlasio4:30 pm to 5:00 pm Tomorrows Expectations Dick
DeBlasio
-
IEEE SA SCC21 1547.1 Full Revision WorkshopAGENDA DAY TWOOctober
2, 2014
8:00 am to 8:30 amSign In8:30 am to 10:30 amReach Closure
Establish a Final Draft Straw man TITLE/SCOPE/PURPOSE. Is there a
convergence of technical ideas? Are the recommendations and
rationale transparent? Any Fine tuning?Dick DeBlasio, Tom
Basso10:30 am to 11:00 am Break11:00 am to 12:00 pm Next Steps
Tom Basso, Justin Caso
12:00 NOON (Lunch on your own) Meeting Adjourned Thank You!
-
IEEE Standards Classification
Standards: documents with mandatory requirements (shall)
Recommended Practices: documents in which procedures and
positions preferred by the IEEE are presented (should)
Guides: documents in which alternative approachesto good
practice are suggested but no clear-cut recommendations are made
(may)
-
*
-
**Title: IEEE Std. P1547 Standard for Interconnection and
Interoperability of Distributed Energy Resources with Associated
Electric Power Systems Interfaces. Scope: This standard establishes
criteria and requirements for interconnection of distributed energy
resources (DER) with electric power systems (EPS) and associated
interfacesPurpose: This document provides a uniform standard for
the interconnection and interoperability of distributed energy
resources (DER) with electric power systems (EPS). It provides
requirements relevant to the interconnection and interoperability
performance, operation and testing, and, safety, maintenance and
security considerations. IEEE P1547 - Full Revision - PAR Approved
March 27,2014
-
**Title: Draft Standard Conformance Test Procedures for
Equipment Interconnecting and Interoperable with Distributed Energy
Resources, Electric Power Systems and Associated Interfaces Scope:
This standard specifies the type, production, and commissioning
tests and evaluations that shall be performed to demonstrate that
the interconnection and interoperable functions and equipment of a
distributed energy resource (DER) conform to IEEE Standard 1547.
Purpose: Interconnection equipment that connects DER to an electric
power system (EPS) must meet the requirements specified in IEEE
Standard 1547. Standardized test procedures are necessary to
establish and verify compliance with those requirements. These test
procedures must provide both repeatable results, independent of
test location, and flexibility to accommodate a variety of DER
technologies. Where physical tests are not practical, evaluation
techniques using analysis and simulations are established. P1547.1
(full revision) Initial Straw Man PAR
-
*Ideas for Testing: e.g. see P1547 [full revision] Minutes; and,
your ideas/experience [solutions-based?]: Interoperability relative
interface coordination portal tests Communications and control
portal testsEvaluation analysis and simulationNeed vs. risk for
testing System-level vs. components Periodic tests and evaluations;
changes after installed etc.
Ideas from industry:Last, Fnamei) Last, Fnameii)Last, Fnameiii)
Last, Fname
-
Industry Suggestions P1547.1 **
Industry Suggestions -- P1547.1 (full revision PAR) Basso,
TTitle: Draft Standard Conformance Test Procedures for Equipment
Interconnecting and Interoperable with Distributed Energy
Resources, Electric Power Systems and Associated Interfaces. Basso,
TScope: This standard specifies the type, production, &
commissioning tests, and, other tests or evaluations that shall be
performed to demonstrate that the interconnection and interoperable
functions and equipment for a DER conform to IEEE P1547. Where
physical tests are not practical, evaluation techniques, such as
analysis or simulation, are specified. Conformance is established
through a combination of type (also known as design tests),
production, commissioning, and periodic tests, and by installation
evaluation and other evaluations. Basso, TPurpose: Conformance of
equipment for interconnection and interoperability needs to be
validated through standardized tests, procedures and evaluations
that provide both repeatable results, independent of test location,
and, flexibility to accommodate a variety of DER technologies and
functions. It is recognized that functions and equipment providing
interconnection and interoperability can be integrated into a
single device or as an assembly of components, each satisfying a
limited set of requirements. Components satisfying a limited set of
requirements need to be tested for those requirements in accordance
with this standard. Basso, T
-
*Ideas/experience (solutions-based) from Industry for
Testing
Ideas from industry:Last, Fnamei)
Last, Fnameii)
Last, Fnameiii) etc.
Last, Fname
-
Industry Suggestions P1547.1 **
Industry Suggestions -- P1547.1 (full revision PAR) Last, Fname
Title: Draft Standard (for) ...
Last, Fname Scope: (This standard covers/addresses)
Last, Fname Purpose: (The purpose/needs)
Last, Fname
-
If interested, please provide your ideas by filling in the last
two slides and return to [email protected] and
[email protected] -------------- ---------------------
-----------Fostering Technological Innovation and Excellence For
The Benefit Of Humanity
Thank You *
**
