7/25/2019 i ALERT2 Installation Guide
1/1
i-ALERT2 Application Guide 25 of 54
MOUNTING METHODS
There are three methods that can be used to mount the i-ALERT2
deviceto a machine. They are shown in the figure below.
On new pumps and pumps repaired through ITT PRO Services, a slot
will be milled into an appropriate location on the
bearing housing and the device will be secured with a screw.
Alternatively, a hole can be drilled and tapped and a small
adapter plate can then be used to secure the device. Lastly, the
device can be epoxied directly the machine via the
mounting plate. Make sure to use a good quality, rigid epoxy. Do
not use RTV or Silicon to mount the device.
CAUTION:
Always wear protective gloves. The equipment and the
i-ALERT2device can be hot.
Mill a Slot Drill and Tap Epoxy
Screw: -28 x 1.125in Screw: -28 x 1.5in Screw: -28 x 1.125in
Slot: 2.25in L x 1.6in W Tap: -28 UNF x in deep Epoxy:
application specific
COMMISSIONING
STEPS TO ACTIVATE THE I-ALERT2 EQUIPMENT HEALTH MONITOR:
1. Remove the sticker.
2. The i-ALERT2 devicewill look for light. Note: If in a dark
environment use light source to activate.
3. When activated a sequence of flashing LEDs will start to
indicate that the unit is powered on.
4. When sequence is completed the green LED will flash every 5
sec under normal operating conditions
Figure 23: Mounting Methods
