HP P4014 RESET Cold reset A cold reset unlocks menus that have been previously locked and returns all of the control panel menu items (including EIO settings) to the factory defaults. However, it does not clear the values in the SERVICE menu (such as the serial number and page counts). NOTE: Before performing a cold reset, print a menu map and a configuration page (see Print the information and show-me-how pages on page 66). Use the information on the configuration page to reset any customer-set configuration values that the cold reset procedure changes. To perform a cold reset 1. Turn the product power off. 2. For HP P4010/4510 Series printers: Turn the product power on, and then hold down OK when the memory count begins. 3. Continue holding down OK until all three control-panel lights flash once and then remain on. This might take up to 10 seconds. 4. After the SELECT LANGUAGE message appears on the display, press (Up Arrow button) or (Down Arrow button) until COLD RESET is highlighted. 5. Press OK. The product performs a cold reset and then continues its power-on sequence. 6. Check all I/O settings and reset any customer-set configuration values. NVRAM initialization CAUTION: Initializing NVRAM resets the serial number, the event log, the page counts, the calibration settings, and the EIO card. Use the SERVICE menu to restore the serial number and page counts. You also need to reconfigure any computers that print to this product to recognize the product. Initialize NVRAM only when absolutely necessary. In most situations, use a cold reset to reset product variables but still retain the needed values in the SERVICE menu.

Hp p4014 Reset

Download DOCX Report

Upload
manuel-londono
View
18
Download
3

Embed Size (px)

Citation preview

HP P4014 RESET

Cold reset

A cold reset unlocks menus that have been previously locked and returns all of the control panel menuitems (including EIO settings) to the factory defaults. However, it does not clear the values in theSERVICE menu (such as the serial number and page counts).

NOTE: Before performing a cold reset, print a menu map and a configuration page (see Print theinformation and show-me-how pages on page 66). Use the information on the configuration page toreset any customer-set configuration values that the cold reset procedure changes.

To perform a cold reset1. Turn the product power off.2. For HP P4010/4510 Series printers: Turn the product power on, and then hold down OK whenthe memory count begins.3. Continue holding down OK until all three control-panel lights flash once and then remain on. Thismight take up to 10 seconds.4. After the SELECT LANGUAGE message appears on the display, press (Up Arrow button) or(Down Arrow button) until COLD RESET is highlighted.5. Press OK. The product performs a cold reset and then continues its power-on sequence.6. Check all I/O settings and reset any customer-set configuration values.

NVRAM initialization

CAUTION: Initializing NVRAM resets the serial number, the event log, the page counts, the calibrationsettings, and the EIO card. Use the SERVICE menu to restore the serial number and page counts. Youalso need to reconfigure any computers that print to this product to recognize the product. InitializeNVRAM only when absolutely necessary. In most situations, use a cold reset to reset product variablesbut still retain the needed values in the SERVICE menu.

Before initializing NVRAM, print a configuration page and a supplies status page to gather the followinginformation:

● Total page count

● Serial number

1. Turn the product on and watch the control panel display.2. When the display shows the memory count, press and hold the down arrow until all three lightson the control panel are lit.3. Press the up arrow .4. Press Menu . The message SKIP DISK LOAD displays on the control panel.5. Press the up arrow until NVRAM INIT is highlighted, and then press OK. The product initializesNVRAM and then continues its power-on sequence.