HP eStation Zeen Ground Wire ReplacementThis guide is used to replace the Ground wire of the HP eStation Zeen MotherBoard.

Written By: dalton hale

HP eStation Zeen Ground Wire Replacement Draft: 2018-10-01Guide ID: 71793 -

This document was generated on 2019-10-04 09:37:16 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

INTRODUCTION

If the troubleshooting procedures and all of the previous steps do not work it may be time to changethe motherboard ground wire.

TOOLS:Phillips #0 Screwdriver (1)Metal Spudger (1)Soldering Iron (1)Tweezers (1)iFixit Opening Tools (1)

HP eStation Zeen Ground Wire Replacement Draft: 2018-10-01Guide ID: 71793 -

This document was generated on 2019-10-04 09:37:16 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — Motherboard Ground Wire

Remove the screw caps using a metal spudger.

Remove the four 6 mm screws using a Phillips #0 screwdriver.

Step 2

Insert a plastic opening tool into the case seam and slide it along the edges.

Lift and remove the back panel from the device.

HP eStation Zeen Ground Wire Replacement Draft: 2018-10-01Guide ID: 71793 -

This document was generated on 2019-10-04 09:37:16 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

Step 3

Carefully disconnect the battery clipusing small plastic spudger.

The clip is extremely fragile.

Step 4

Use tweezers to disconnect theground wire from motherboardterminal.

HP eStation Zeen Ground Wire Replacement Draft: 2018-10-01Guide ID: 71793 -

This document was generated on 2019-10-04 09:37:16 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

To reassemble your device, follow these instructions in reverse order.

Step 5

Use a soldering iron to remove theground wire.

Avoid touching or heating themotherboard.

HP eStation Zeen Ground Wire Replacement Draft: 2018-10-01Guide ID: 71793 -

This document was generated on 2019-10-04 09:37:16 AM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5