15
How to make a simple tempeh incubator. For all information regarding , how to make tempeh or purchasing of materials for tempeh/tofu making please visit www.mrtempeh.com.au

How to make a simple tempeh incubator

  • Upload
    lonna

  • View
    93

  • Download
    0

Embed Size (px)

DESCRIPTION

How to make a simple tempeh incubator. For all information regarding , how to make tempeh or purchasing of materials for tempeh/tofu making please visit www.mrtempeh.com.au. Completed simple incubator. - PowerPoint PPT Presentation

Citation preview

Page 1: How to make a simple tempeh incubator

How to make a simple tempeh incubator.

For all information regarding , how to make tempeh or purchasing of materials

for tempeh/tofu making please visit www.mrtempeh.com.au

Page 2: How to make a simple tempeh incubator

Completed simple incubator.

Page 3: How to make a simple tempeh incubator

• This is a simple set of step by step instructions so that anyone can make a simple, cheap incubator for the home use of making delicious fresh white tempeh!

Page 4: How to make a simple tempeh incubator

You will need:1 Styrofoam box,1 basket that fits inside

the box,2 plastic rods and a 25 watt aquarium heater.

Page 5: How to make a simple tempeh incubator

For tools you will need: 1 measure tape,1 marker,1 knife or hole saw and a drill bit bigger than the diameter of the plastic rods.

Page 6: How to make a simple tempeh incubator

1: mark the expected water level, this needs to cover your aquarium heater generously . 2: Mark the bottom of the hole that you will cut. Leave about 25 mm space between the water level and the bottom of the hole.

3 : cut the hole, about 50 mm diameter so the heater will fit through.

Page 7: How to make a simple tempeh incubator

Once you have cut the hole, round or square, place your basket on the 2 plastic rods and mark where to make the holes ,

about 40 mm below the top , use your drill bit manually, no need for a drill.

Page 8: How to make a simple tempeh incubator

Once you have drilled the four holes, push the plastic rods in position and place the basket on top. It should

be suspended above expected water level and not touching the lid, once it is in position.

Page 9: How to make a simple tempeh incubator

Set the temperature of your heater to 30 Degrees Celcius , feed through the hole and place on the bottom, making sure it is fully submerged under water.

Page 10: How to make a simple tempeh incubator

It should look this this, make sure the water level covering the heater

and turn it on.

Page 11: How to make a simple tempeh incubator

Place the lid on top and check the ambient temperature after 24 hours, it should be around

30 Degrees.

Page 12: How to make a simple tempeh incubator

Once the temperature has stabilized around 30 degrees, proceed to

prepare your beans ,inoculate , put in the bag and place in the basket.

Page 13: How to make a simple tempeh incubator

Place the lid on top, close the box and proceed the fermentation as per instructions that came with your order of the tempeh kit.

Page 14: How to make a simple tempeh incubator

Alternatively you can place a rack on top of some rods and place your

bags on there to ferment.

Page 15: How to make a simple tempeh incubator

Full instructions for successful tempeh making will come with your

order of a tempeh kit or tempeh starter ,

see you at:www.mrtempeh.com.au

thanks and good luck