Embed Size (px)
Citation preview
www.iPhoneZen.com
How to make a nanoSIM card from a SIM or a microSIM
1. Iden0fy your SIM card from the descrip0on below:
12.3mm
8.8m
m
NanoSIM 4FF
cv 12.0mm cv
Actual microSIM 3FF resizable to nanoSIM
15.0mm
cv
Actual SIM 2FF[non micro] resizable to nanoSIM
15.0mm
25.0mm
SIM first genera0on[1989] NOT Compa*ble for 4FF nanoSIM
15.0mm
25.0mm
2. Tools Required:
Marker Marker pen, [CD Labeling type]
CuVer for plas0c, fine cut
Ruler 1 2 3 20 19 18 17
www.iPhoneZen.com. All rights reserved. [email protected]
www.iPhoneZen.com
2. Cutting Mask for resize SIM and MicroSIM to NanoSIM 12.0mm
15.0mm
15.0mm
25.0mm
Actual SIM 2FF[non micro] resizable to nanoSIM
Actual microSIM 3FF resizable to nanoSIM
8.8mm
12.3mm
Align the ruler above the red lines and mark your SIM with the Marker pen
Select your SIM and align it with the related SIM mask below
4FF
4FF
3FF 2FF
2
1
Repeat point 2 for all lines 3
www.iPhoneZen.com. All rights reserved. [email protected]
www.iPhoneZen.com
3. Step by Step procedure.
Identify your SIM. Only those with the smaller chip are compatible for resizing
1
Tools: Marker, Cutter and Ruler. You may also need some tape and scissors
2
Print the “Cutting Mask” page
3
Select your SIM type , 2FF or 3FF, and align it with relevant colored mask in the center of the page.
4
www.iPhoneZen.com. All rights reserved. [email protected]
www.iPhoneZen.com
4. Step by Step procedure.
Placed and taped precisely your SIM card
5
Carve along the drawn lines by paying attention to do not damage the chip
7
Align the ruler with the red reference lines and draw a straight line using the marker. Repeat for all sides following the red reference lines.
6
WARNING: Do not attempt to use the cutter if you aren’t enough expert or not confident to manage the cutting tool. You may ask for an expertise support.
WARNING: A proper SIM cutting tool should be use for resizing . This procedure is intended for demonstration only, therefore we are not responsible for the good functionality data lost or any damage, that my occurred to your SIMs or devices.
www.iPhoneZen.com. All rights reserved. [email protected]
www.iPhoneZen.com
3c. Step by Step procedure.
Gently bend along the carves in order to remove the margins
8 Your new nanoSIM 8.8mm x 12.3mm is ready.
10
Refine the cut with scissors
9
www.iPhoneZen.com. All rights reserved [email protected]
NOTE: Some 2FF Sim cards in market, are not perfectly 25mm x 15mm. Verify that 1mm max gap, between the chip left side and the left vertical reference line.
