1
© 2009 - 2LearnCAD.com - All rights reserved How to draw a line: In this tutorial we will draw a straight line segment by using the Line symbol from the Draw tool bar and the line command. Method 1: 1. Select the line symbol from the draw menu. 2. Select a starting point for the line. 3. Select an end point for the line. 4. Hit Enter. Method 2: 1. Type Line or L in the command line. 2. Hit Enter. 3. Select a starting point for the line. 4. Select an end point for the line. 5. Hit Enter. Method 3: 1. Select the line symbol from the draw menu or type Line or L in the command line. 2. Select a starting point for the line. 3. Move the cursor in the line direction. 4. Enter the length of the line, for example: type 3’ or 3”. 5. Hit Enter. 6. Hit Enter again to get out of the command. If you need any further help, contact me using the contact page or visit the discussion forum site http://www.2learncad.com/forum .

How to draw a line: Method 1 - Learning Autocad - Free ...2learncad.com/pdf/draw-a-line.pdfHow to draw a line: In this tutorial we will draw a straight line segment by using the Line

  • Upload
    buihanh

  • View
    221

  • Download
    4

Embed Size (px)

Citation preview

Page 1: How to draw a line: Method 1 - Learning Autocad - Free ...2learncad.com/pdf/draw-a-line.pdfHow to draw a line: In this tutorial we will draw a straight line segment by using the Line

© 2009 - 2LearnCAD.com - All rights reserved

How to draw a line:

In this tutorial we will draw a straight line segment by using the Line symbol from the Draw tool bar and the line command.

Method 1:

1. Select the line symbol from the draw menu. 2. Select a starting point for the line. 3. Select an end point for the line. 4. Hit Enter.

Method 2:

1. Type Line or L in the command line. 2. Hit Enter. 3. Select a starting point for the line. 4. Select an end point for the line. 5. Hit Enter.

Method 3:

1. Select the line symbol from the draw menu or type Line or L in the command line. 2. Select a starting point for the line. 3. Move the cursor in the line direction. 4. Enter the length of the line, for example: type 3’ or 3”. 5. Hit Enter. 6. Hit Enter again to get out of the command.

If you need any further help, contact me using the contact page or visit the discussion forum site http://www.2learncad.com/forum.