Hole SawsHole SawsAvailable Hole Saw Sizes

Steps for Use:1. Determine diameter and location of desired hole.2. Determine the appropriate speed for cutting based on hole saw diameter. These speeds can be found on the Mill/Lathe/Drill Press Speed Charts.3. For the larger hole saws snap the tightening collar down to prevent over tightening. Use the pilot drill with out tightening collar for smaller hole saws.4. Insert appropriate hole saw into drill press or mill.5. Secure work piece on wood or something that can be cut.6. Cut work piece using oil for lubrication. 7. De-bur edges to prevent cuts.8. Clean up and put tools away.

•Secure/Clamp work piece.•De-bur edges to prevent cuts.•Not for thick metal.

Safety:

Figure 1. Hole saw location cabinet 3 behind collets

The hole saws is used to drill a hole in thin materials, up to a1/2 for metal. A normal drill will try to lift sheet metal off of the table and spin

it.

Purpose:

Vender http://www.MSCdirect.com

www.msdiscount.com

www.mkmorse.com

Figure 2. Hole Saws

Sizes in inches

¾

7/8

1

1 1/8

1 ½

1 ¾

2

2 ¼

2 ½

3

3 ¼

3 5/8

3 ¾

4 1/8

4 ½