High Quality Scart LeadRGB

The Mister FPGA Scart lead, is a high quality video lead, that allows you to connect your Mister FPGA with I/O board, toRGBa TV, via the Scart socket, to display a superb full colour picture with Stereo sound. For those who prefer toR RG GB Bconnect to the TV via the Scart socket, rather than using HDMI video, also present on the Mister FPGA board.

This lead is professionally designed and hand made by Ian Priddey, using quality materials and workmanship. Made fromhigh quality overall foil screened thick wall cable, which is also soft and flexible, and fitted with good quality connectors.

THIS IS A BRANDED PRODUCTRETRO COMPUTER SHACK

For The Board

High quality, overall foilscreened thick wall, cable,for the best quality picture,with no interference. Cableis also soft and flexible.

Good QualityEuro Scart Plug.Plugs into the TV’sRGB Scart Socket.

15 Pin D-SUB connector.Plugs into the MisterRGB/YPbPr socket.

3.5mm stereo audioLead, twin core individuallyscreened cable, Plugs intothe Line Out socket on theMister board. Sendssound to the Scart plug.

A 470 RESISTOR IS FITTED TO THE CSYNC SIGNAL ON PIN 20 OF THE SCART PLUGΩ

CSYNC SIGNAL (PIN 20 OF SCART PLUG)A resistor is fitted to the CSYNC signal on pin 20 of the Scart plug.470ΩWhen the Scart Lead is plugged into the TV’s Scart socket, this attenuatesthe CSYNC signal to a maximum of about 550mV peak (344mV RMS).This makes the lead fully compliant with Scart specifications.

Mister I/O board Scart lead connections

Mister FPGA I/O board, and socketsAudio Video

SCART LEAD IS 2 METRES IN LENGTH

forced_scandoubler=0ypbpr=0composite_sync=1vga_scaler=0

MISTER.INI FILE SETTINGS FOR 15Khz RGB SCART USE

A good knowledge of configuring the Mister board will be required to use this lead.PLEASE ONLY BUY THIS LEAD, IF YOU ARE COMPETENT IN DOING THIS.

The basic settings are listed below, and may differ, depending on the core and TV used.The core used must be able to output a 15Khz TV picture, to work with a Scart lead.

IMPORTANT! PLEASE READ

YOU WILL NEED TO MANUALLY SELECT THE

SCART INPUT ON THE TV TO USE THIS CABLE

SWITCH OFF THE MISTER FPGA AND TV BEFORE CONNECTING THE SCART LEAD

http://www.RetroComputerShack.com