1HEAT EXPANSION & CONTRACTION

What changes in dimensions occur when heat is extracted or added to a system ?

2

How does a change in temperature affect the dimensions of a system?

Give examples where you have to consider the changes in the dimensions of a system when heat is added or extracted

3

• DEMO: Heating of Iron wire?• Show expansion of wire as the result of heating.

• Day 2:• DEMO: Heating of Iron wire?• Show expansion of wire as the result of heating.

Possible demos you might have seen:(don’t try these at home, watch on youtube)

1.Heat/cool bimetallic strip- curls up! 2.ball/ring- ring expands-hole gets bigger 3.drop hot skillet into cold water- warps!4. Hot wire foam cutter- wire gets thicker5. Thin film coatings- dr.v lab pictures6. Shrink tubing- heat activates chemical reaction

7. Caliper reading of hot vs cold copper

Tempered glass: breaks into pieces since faces hold in middle: top & bottom under compression, middle is under tension.

Cracks on surfaces: called crazing, surface cools faster than inside, different in contraction causes stress cracks

Outer surface cools faster, and if same material,inside holds back contraction so outside under tension

9

A iron disc with a hole in it is heated.

Will the diameter of the hole (a) increase, (b) decrease or (c) not change?

Q

10

Holes get bigger

11

T1 < T2

Q

As metal expands, the distance between any two points increases. A hole expands just as if it’s made of the same material as the hole.

12

A nut is very tight on a screw. Which of the following is most likely to free it?

(a) Cooling it(b) Heating it(c) Either(d) Neither

13

Bimetallic strips Two strips of different metals welded together at one temperature become more or less curved at other temperatures because the metals have different values for their coefficient of linear expansion .

They are often used as thermometers and thermostats

lower metal expands more than upper metal when heated

Q

14Most solids and liquids expand when heated. Why?

Internal Energy U is associated with the amplitude of the oscillation of the atoms

Average distance between atoms

Inter-atomic forces

“springs”

15Collisions of thermally oscillating atoms make them shift further apart

PE

Separation of atoms

Solid heated increased vibration of atoms increase max displacement either side of equilibrium position vibration is asymmetric mean distance increases with increasing temperature

THERMAL EXPANSION

Attractive force

Repulsive force

average distance between atoms

E1

E2

E3

16

Ceramics (deep PE troughs) low expansion coefficients

~10-6 K-1

Polymers high expansion coefficients

~ 10-4 K-1

Metals

~ 10-5 K-1

oL L T LINEAR THERMAL EXPANSION

coefficient of linear expansion

17

Lo

L

A

Ao Vo

V

L

oL L T o2A A T

o o3V V T V T

Linear Area Volume

* Simple model: assume and are independent of temperature, T < 100 oC* Wood expands differently in different directions

18

Water has an anomalous coefficient of volume expansion, is negative between 0 °C and 4 °C.

Liquid water is one of the few substances with a negative coefficient of volume expansion at some temperatures (glass bottles filled with water explode in a freezer) – it does not behave like other liquids

T > 4 °C water expands as temperature increases

0 < T < 4 °C water expands as temperature drops from 4 °C to 0 °C

T = 3.98 °C water has its maximum density

19

0.9998

1

1.0002

1.0004

1.0006

1.0008

1.001

1.0012

1.0014

1.0016

1.0018

1.002

0 4 8 12 16 20

temperature T (°C)

998

998.2

998.4

998.6

998.8

999

999.2

999.4

999.6

999.8

1000

1000.2

volumedensity

density (g/mL)volume V (L) WATER 1 kg sample kg.m-3

mV

20BUOYANCY - FLOATING AND SINKING

Why do ice cubes float on water?

21Lakes freeze from top down rather from bottom up

Water on surface cools towards 0 °C due to surrounding environment. Water as it cools and becomes more dense, it sinks carrying oxygen with it (it is most dense at about 4 °C). Warmer water moves up from below. This mixing continues until the temperature reaches 4 °C. Water then freezes first at the surface and the ice remains on the surface since ice is less dense than water (0.917 g/mL). The water at the bottom remains at 4 °C until almost the whole body of water is frozen. Without this peculiar but wonderful property of water, life on this planet may not have been possible because the body of water would have frozen from bottom up destroying all animal and plant life.

22

Problem B.1

As a result of a temperature rise of 32 °C a bar with a crack at

its centre buckles upward. If the fixed distance between the

ends of the bar is 3.77 m and the coefficient of linear

expansion of the bar is 2.5x10-5 K-1, find the rise at the centre.

23Solution

Identify / Setup

2Lo

h = ? mL L

T = 32 °C = 2.510-5 K-1

Lo = 3.77/2 m = 1.885 m h = ? m L = ? m

Linear expansion

L = Lo + L = Lo + Lo T

L

Lo

h

24Execute

From Pythagoras’ theorem

L2 = Lo2 + h2

h2 = L2 – Lo2

= (Lo + Lo T)2 – Lo2

= 2 Lo2T + 2 Lo

2 T2

h = (2 T)½ Lo neglecting very small terms

h = {(2)(2.510-5)(32)}½ (1.885) m

h = 0.075 m Evaluate

25

Problem B.2

When should you buy your gas to get the most for your money?

2 pm 2 am

26

Buy it when it’s cooler- more dense

2 pm 2 am

o o3V V T V T

27

Problem B.3

A square is cut out of a copper sheet. Two straight scratches on the surface of the square intersect forming an angle  . The square is heated uniformly. As a result, the angle between the scratches

A increasesB decreasesC stays the sameD depends on angle being acute or obtuse

θ

28

Problem B.4

A surveyor uses a steel measuring tape that is exactly 50.000 m at a temperature of 20 oC. (a) What is the length on a hot summer day when the temperature is 35 oC? (b) On the hot day the surveyor measures a distance off the tape as 35.794 m. What is the actual distance?

steel = 1.210-5 K-1

29Solution I

L0 = 50 .000 m T = 15 oC = 1.210-5 K-1

L = L0(1 + T) = 50.009 m

Part (b) is “tricky”

The actual distance is larger than the distance read off the tape by a factorL / L0

true distance = (35.794) (50.0009) / (50.000) m = 35.800 m

expansion by a factor 2

Possible lab: how would you find the linear expansion coefficient of a spring?

Given: ice, hair dryer, spring, mass, temperature meter

Drawing is by Courtesy of the University of Minnesota.www.ph.utexas.edu/~phy-demo/demo-txt/1r10-10.html

lab: how would you find the linear expansion coefficient of a wire pendulum?

Given: ice, hair dryer, wire, mass, temperature meter, stop watch

Drawing is by Courtesy of the University of Minnesota.www.ph.utexas.edu/~phy-demo/demo-txt/1r10-10.html

Lab pictures