USER MANUAL

MODEL: BEN - 6030AHD

PANEL FUNCTION

WIRING DIAGRAM

INSTALLATION

Step 1 >>

Step 4 >> Step 5 >> Step 6 >>

Step 2 >> Step 3 >>

3cm

1cm

Step 3: Connect the camera cable to the back site of Digital Video Recorder (DVR). Signal cable connects to the BNC jack. The connection of camera cable and BNC jack is in the image below:

MODEL BEN - 6030AHD

SPECIFICATION

Resolution HD (1280 x 720)

Focal Length

IR

Vision

Dimensions

Indoor - Outdoor / Day - Night

30 LedsIR distance 15 - 20m

Image Sensor

3.6mm - 6mm optional

1/4'' 1.0 Megapixel Cmos

(L)20.5cm*(W)7.2cm*(H)6.5cm

INSTALLATION NOTICES

1. Electrical SafetyFor safety in instalation, ensure that the correct DC voltage is supplied to your camerasor they will suffer permanent damage.Don’t plug out when instalation haven’t finished

2. Delivery Safety

3. AccessoriesYou should use accessories as guest of manufacturer. Ensure that there are enough accessories in the production package before instalation.

4. Daily remainningUnplug the power before cleaning. Firstly using wet towel to wash then cleaning again by dry one.Using a sponge or nonmetal soft brush to clean lens.

Step 1: Install camera to the decided position Drill 3 or 4 holes of the installed surface. Use screws for fixing the sole to the wall surface (amount of screw depend on each bullet camera). If install on the wood surface, directly screw on the wood surface.

Step 2: Loose the horizontal adjusting ringb and adjust the camera to the surveilance areas, then fix the horizontal adjusting ring back

Camera has two cables: Signal cable and Power cable. Power cable connects to the 220V Power, switch to 12V for camera running. Signal cable connects to the DVR.

Step 4: After connecting camera with DVR, continuing connect to the Television or Computer. System connection is in the chart below:

LED

Cover

Bullet

LenLight Sensor

Cameras are fragile so you need attention not to crush or fall down them. Leds or cover can be brocken or fai led