Upload
bryony
View
22
Download
0
Tags:
Embed Size (px)
DESCRIPTION
GPS Location Saving System Hardware Review. WWU Taylor Reijm. GPS Location Saving System Full Schematic. NXP LPC2378 ARM7 MCU. LPC2378 32-bit MCU 512kB Flash Memory 144-pin 20MHz oscillator Used to control TFT touch screen LCD and LCD controller. - PowerPoint PPT Presentation
Citation preview
GPS LOCATION SAVING SYSTEM HARDWARE
REVIEWWWU
Taylor Reijm
GPS Location Saving System Full Schematic
NXP LPC2378 ARM7 MCU
LPC2378•32-bit MCU•512kB Flash Memory•144-pin•20MHz oscillator•Used to control TFT touch screen LCD and LCD controller.•1 GPIO used for automatic power off circuitry•RXD3 and TXD3 used to interface with GPS Receiver.
Power Supply Circuitry
•7.2V NiMH battery with 3000mA hrs.•IRFZ44N VGS=2V to start conduction.•VGS=0V to end conduction.•GPIO and SW2 used to control conduction•ATPS006A0X Pico TLynx DC-DC switching power module.
• Fixed Switching Frequency• Remote On/Off• 4.5Vdc-14Vdc• 6A
•Trim resistance used to get output of 5V• RTRIM=[5.91/(Vo -0.591)]k ohms• RTRIM(5V)=1.34k ohms
NCP1117•18V max in•3.3V out•800mA output current
TFT LCD and Controller
ADS7843- Touch screen controller•12 bit ADC with synchronous serial interface•Comes connected as shown from Gravitech
ELT240320TP-TFT LCD•Thin Film Transistor Touch screen interface•2.8” screen 240x320 pixels.•Backlight control•Cap Sense O/P
Reset Circuitry
•Active low reset
Oscillator and EEPROMOscillator•20MHz oscillator with enable tied to 3.3V supply
EEPROM•8kB•I2C interface w/LPC2378
GPS Receiver
EM-406A• 4800 baud NMEA 0183 output• 4.5V~6.5V DC input supply• ~44mA • O/P voltage level 0V to 2.85V• One Pulse Per Second not used.