0

50

100

150

200

250

300

lb/A

MycoApply EndoPrime 4 grams/A In-Furrow

Yield Compared To Untreated

Go Where Roots Can’t with MycoApply® EndoPrime®Applied in-furrow, MycoApply® EndoPrime® uses four unique species of mycorrhizal fungi to help improve nutrient efficiency, drought tolerance and protect yield potential.

� Improved nutrient access and uptake—Hyphae can access small areas that root hairs can’t. They also produce enzymes to release nutrients that are tied up in the soil.

� Drought stress tolerance—Mycorrhizae can store resources until needed by the plant

� Improved soil structure—Hyphae produce glomalin, which creates stable soil aggregates for better soil structure

� Expanded root absorption—Hyphae extend from roots to access areas inaccessible to bigger roots

MycoApply EndoPrime Cotton Yield Summaries—AL, GA, FL

MycoApply EndoPrime Peanut Yield Summaries—AL, GA, FL, NC

| Cotton & Peanuts |

-400

-200

0

200

400

600

800

lb/A

MycoApply EndoPrime 4 grams/A In-Furrow

Yield Compared To Untreated

MycoApply EndoPrime TreatedUntreated

Untreated MycoApply EndoPrime Treated

Yield Average +82 lb/A

Yield Average +254 lb/A

Products That Work, From People Who Care® | valent.com | 800-6-VALENT (682-5368)

Always read and follow label instructions. Products That Work, From People Who Care is a registered trademark of Valent U.S.A. LLC. MycoApply and EndoPrime are registered trademarks of Mycorrhizal Applications LLC. ©2019 Valent U.S.A. LLC. All rights reserved. Printed in the U.S.A. 2019-MAEP-8001 LF 1/19

How To UseRate 4 grams/A (each 320-gram package treats 80 acres)Application In-furrowNotes • The goal is for the solution to come in contact with the seed or roots

• Refer to COMPATIBILITY WITH OTHER AGRICULTURAL PRODUCTS section when mixing with other products

• Screen size: Use filters or screens no finer than 50 mesh

In-Furrow Application PreparationMycoApply EndoPrime must be mixed with water (slurry) prior to adding to carrier (liquid fertilizer or water) in application tank. Prepare slurry by mixing MycoApply EndoPrime to water at a ratio not to exceed 320 grams in 2 gallons of water, make only enough slurry to treat one load.

To Prepare Slurry: Add half the water to the slurry container, add MycoApply EndoPrime, followed by the remaining water volume. Agitate by paddle stirring or shaking in a jug until fully dispersed in slurry solution. Ensure that all material is fully dispersed in the slurry prior to adding to the application tank.

Add slurry of water and MycoApply EndoPrime to carrier that is in the application tank. Make only enough slurry to treat one tank of carrier.

Mixing Order for Tank Mix Partners by Formulation Type1. Carrier (water or liquid fertilizer)2. Wettable granules (dry flowables)3. Wettable powders4. MycoApply EndoPrime5. Aqueous solutions6. Emulsifiable concentrates7. Adjuvants