Embed Size (px)
Citation preview
Need to GrabAlcohol
IncludedPliersGlock
Install ToolRed Thread
Locker File HammerAllenKey
Rear Sight(Set Screws
installed)
Front Sight & Screw Q-tips
(5-10)
Before installing or adjusting your sights, unload and/or check to ensure the firearm is unloaded.
Questions or Problems? Ask the XS Tech Team: (888) 744-4880 | [email protected] | 8:30am-5:00pm CT
Punch
Acetone, gunscrubber, brake cleaner, etc.
Glock Installation
Remove slide, recoil spring & barrel per GLOCK® Owners Manual1
Degrease Contact Surfaces
Remove existing sights2
3
“Use pliers to remove pinned front sight. Use XS®’s Glock Install Tool to remove front sight with hex screw.”
Alcohol
5
7
4
6 AssembleLiberally Apply Red Thread Locker
Check Alignment
“Barely finger tight! Screw shears easily”
Check.Test fit XS® Sight. Remove Sight.
“G36 models may require head of screw to be thinned.”
Delrin, Nylon,or Brass
15
11
12
14
“DON’T OVER TIGHTEN, the Red Threadlocker next will hold the sight in place. Overtightening can kill the tritium vial.”
Liberally Apply Red Thread Locker Along Edges
Tighten both set screws finger tight
Check Alignment
NOT ONSET SCREWS
16 Lightly wipe excessThread Locker
Let ThreadLocker set for 15 minutes
Questions or Problems? Ask the XS Tech Team: (888) 744-4880 | [email protected] | 8:30am-5:00pm CT
17 Let Thread Locker cure for
3 hours before shooting
10
9
MOVE ONto Step # 13
*If sight can be pushed to the center of the slide...
Lightly wipe off excess Thread Locker
Insert Rear Sight (with FINGER PRESSURE only)
SightPusher
**If not, file as needed until the sight presses in.
“Slow & steady wins the race!Place file flat on table & take off a little at a time.”
Rotate 180°.
4)
3)
2)
1)
Rep
eat a
s ne
eded
Press in.
File
2x’s
File
2x’s
File
8 Let Thread Locker set for 15 minutes
“It’s okay if it loosely slides through. The thread locker in step 13 will keep it in place.”
13 If you so choose, test fire a few rounds to confirm windage zero. Rear sight will begin to move after a few rounds.
