Upload
reuben
View
21
Download
3
Tags:
Embed Size (px)
DESCRIPTION
z. r. Algorithmic Development: Multi-Timescales - PowerPoint PPT Presentation
Citation preview
Force with layering term removed Simulations of Electrowetting at NanoscalesThe new multigrid Coulomb method described above allowed tests of the Young-Lippmann equation in droplets as small as 155nm) in radius.Short chain molecules like those in capillary adhesion simulations were used.
The density contours below show the decrease in contact angle as the number of charges and the associated voltage increase. The charge remains highly localized at the surface of the insulator.
The Young-Lippmann equation describes the changes in in these nanoscale drops. As in macroscopic experiments, there is a saturation at large voltages. Increasing the chain lengthincreases the saturation voltageby preventing molecules fromevaporating under the highelectrostatic force. This is a newmechanism for saturation
-0.2
0
0.2
0.4
0.6
40
50
60
70
80
90
100
1100 50 100 150 200 250 300
EWOD with 12.68 m PDMS on Gold
Experimental Data
Young-Lippmann Equation Fit
cos
Co
nta
ct A
ng
le,
Voltage (V)
saturation
Electrowetting at Nanoscales:
Active nanodevices require means of changing capillary forces. We areexploring control of by electric fields and optical illumination.
Applying a voltage V between a fluid and anelectrode covered by an insulator of dielectric d
and thickness d leads to a new contact angle EW At macroscopic scales this is described by theYoung-Lippmann equation:
cos EW = cos 0 + 0d V2/2dwhere 0 is the equilibrium angle and the liquid surface tension.The curves below show mm scale measurements by our team
Interfacial Forces in Active NanodevicesInterfacial Forces in Active Nanodevices(NIRT 0709187)(NIRT 0709187)
S. Chen, S. Cheng, J. Frechette, R. Gupta, J. Liu, J. Ma, P. M. McGuiggan, M. O. Robbins: Johns Hopkins UniversityS. Chen, S. Cheng, J. Frechette, R. Gupta, J. Liu, J. Ma, P. M. McGuiggan, M. O. Robbins: Johns Hopkins University
Project Overview
As device dimensions shrink into the nanometer range, interfacial forces become increasingly important. At the same time, traditional continuum theories of interfacial forces become inadequate, and fundamentally new phenomena appear. The goals of our project are to determine the limits of traditional theories, identify new interfacial phenomena, develop general models for interfacial forces at the nanometer scale, and explore processes that may enable new active nanodevices. To achieve these goals we are developing and applying new experimental and theoretical methods that allow measurement of interfacial forces on nanowires and in nanometer gaps between solid surfaces and the control of these forces using electric fields and light.
Algorithmic Development: Multi-Timescales
A continuum-atomistic multi-timescale algorithm was developed [1]. Interfacial regions are treated atomistically, while a continuum description is used for bulk regions. The two are coupled through an overlap region. There remains a large gap between the time scales of atomic and bulk regions. The new algorithm integrates atomistic equations for short intervals and then extrapolates over the bulk time interval.
Tests of Couette flow driven by an oscillating wall show that substantial speedups can be achieved and that errors decrease as the separation between time scales grows.1. J. Liu, S. Chen. X. Nie & M. O. Robbins, Commun. Comput. Phys. 4, 1279 (2008).
Droplet density contours
Charge density contours
Algorithmic Development: Multi-Grid Coulomb Method
Studies of electrowetting require efficient algorithms for the long-range interaction between charges. An efficient multi-grid method has been developed. It has enabled the studies of electrowetting described below, as well as simulations of electro-osmosis. Figures below show the charge distribution and effect on flow rate Q in rough channels.
Effect of roughness on flow rateCharge density distribution
50 nm radius InAs nanowire2
2. Prepared by Brian Swartzentruber, Doug Pete, and Tom Picraux as part of a Sandia CINT User Proposal #U2008A160: Fabrication of Nanowires attached to AFM cantilevers
3. Prepared by Frank Zhu at Johns Hopkins University using a FIB to mill the nanowire from a Si cantilever
4. Prepared from solution by NaugaNeedles, LLC
250 nm radius Si nanowire3200 nm radius Ag2Ga nanowire4
Wetting Measurements of Nanowires by AFM
The atomic force microscope (AFM) is being used to measure capillary forces on nanowires as they are pulled through an air/liquid interface. The effects of surface chemistry, nanowire roughness and radius, and velocity are being studied.Examples of nanowires under study are shown below.
Measuring the entire force curve as a nanowire is pushed/pulled though an air/fluid interface gives independent information about interfacial tension, contact angle, dynamic contact angles and hysteresis[5]. Future work will examine changes induced by electric fields and light, and the potential for switching the interface between different states.
ERrz
cos1
4lnsin
Measured force on200nm Ag2Ga nanowire pushed into and retracted from water interface
Forces consistent with bulk surface tension and contact angles:θadv = 58°, θrec = 47°
Capillary force on rodsCan ignore gravity for small rods R ≡ r (g/)0.5 < 1
Away from end: F/r = 2cosContact angle hysteresis → Measure different angles as advance adv and recede rec Both vary with rate of motion
Interface pinned at end. Peak force Fmax = 2r
approach
retract
Watercontact
Water detaches
5. McGuiggan PM, Wallace JS (2006) J. Adhesion, 82: 997-1011. Lyons CJ, Elbing E, Wilson IR (1984) J. Coll. Int’ Sci., 102: 292-294.
Φ = 90 - θ
r
θz
Simulations of Nanocapillaries:
• Generic behavior studied first with Lennard-Jones interactionsLiquid – short chain molecules with FENE bondsLJ units: energy ~ 0.01eV, length ~ 0.3nm, force / ~ 5pN.
• Study effect of atomic structure of surfacesRigid spheres (8 ~ 120nm), bent or cut, crystalline or amorphousRigid or elastic substrate, (111) surface of fcc
• Control through solid-liquid interactions • Compare adhesive force and internal capillary pressure to
continuum theory.• Relate differences to molecular scale properties and structure.
z
r
Results for capillary force F on sphere:• At large h, exact theoretical results and the commonly
used circle approximation are almost identical.Both are consistent with MD results.
• At h < 12σ ~ 4nm, MD results deviate from continuum.There are large oscillatory forces related to layering of fluid molecules that vary with R.
• The contributions to F can be resolved spatially into components from the surface tension at the edge of the drop, the Laplace pressure at intermediate r, and structural forces in a central layered region.
• Discrepancies from continuum theory remain even after removing the oscillatory component.
• Disjoining pressure effects lead to non-hydrostatic pressures in the outer region of the drop.
• The pressure in the plane of the drop is consistent with bulk expressions for Laplace pressure and the bulk The adhesive force is determined by the z-component of the pressure, which is systematically less negative.
Nanoscale Electrowetting in the Surface Force Apparatus
Surface Forces Apparatus
spring
objective
Piezo
disks
Double cantileverspring (stiff)
Helical spring (soft)
White light
Transmitted light
spectrograph with camera
Fringes of Equal Chromatic Order (FECO)
Image analysis
spring
objective
Piezo
disks
Double cantileverspring (stiff)
Helical spring (soft)
White light
Transmitted light
spectrograph with camera
Fringes of Equal Chromatic Order (FECO)
Image analysis
r1
R
θ lv
xL
r1
R
θ lv
xL
The surface force apparatus (SFA) allows study of liquids between surfaces with nanometer separation. The thickness can be measured optically with subnanometer resolution.
SFA experiments can measure the capillary forces described above and changes in force from electrowetting. Applying voltages to patterned electrodes on the mica surfaces can also change the droplet configuration via electrowetting effects.
Current work shows that films can be condensed and evaporated by an applied field, creating another mechanism for controlling fluid geometry at nanometer scales.
ΔV
Young-Lippmann
R