Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Patented
Stonco is a Philips group brand
Architectural Floodlight
One Fixture,Three Distributions,Unlimited Lighting Possibilities
Stonco’s new FloodPak® is the ultimate in exterior lighting versatility. It is the perfect blend of performance, flexibility and architectural design. The FloodPak® is three fixtures in one! It’s a high-performance cutoff luminaire for perimeter
and site lighting. Rotate it 22.5° and it’s a semi-cutoff luminaire offering forward throw. Rotate it to 45° for floodlighting or turn it over to create indirect/accent lighting—the possibilities are endless.
CutoffComplies with local Dark Sky requirements.
Site LightingPole mounted using shoebox-style arm accessory.
Facade LightingGround mounted for above-horizontal aiming.
Forward ThrowDayForm styling provides consistency in multiple applications.
Indirect LightingMaximum versatility from a single outdoor fixture.
Surface MountQuickly adjusts to different lighting requirements.
Lowest Installed Cost
1) Fewer Fixtures RequiredWhen mounted at 0 degrees, the FloodPak® offers a wide Type II distribution with a spacing ratio of up to 6:1. This permits greater spacing between fixtures than conventional wallpack luminaires. Fewer fixtures equals lower cost.
2) Reduced Installation TimeThe FloodPak® features quick and easy installation. By design, the FloodPak® installs in half the time as compared with conventional surface and pole mounted lighting products. Faster installation translates into lower labor costs.
3) Less Energy ConsumedBecause fewer FloodPaks are required, less energy is consumed. Less energy results in lower operation costs.
Designedto MeetToday’sLighting ChallengesGreater Efficiency than Traditional Wallpacks
With conventional wallpacks, up to 70% of the available light never reaches its destination. Approximately 40% is lost within the fixture, while an additional 30% is directed outward and upward above 90°. The FloodPak’s high performance places 80% of the available light down and out where it is needed resulting in fewer fixtures, better lighting and greater savings.
Meets Dark Sky and Light Trespass Requirements
The FloodPak® cutoff luminaire is designed around a high-performance, multifaceted optical system that meets today’s strict IESNA Dark Sky requirements. When mounted at 0° the FloodPak® directs all of the light below 90° reducing glare and ensuring compliance to local “Dark Sky” codes. Tipping the FloodPak® up 22.5° redirects the light forward allowing control over light trespass issues.
A Family of Fixtures
The FloodPak® family is available in three sizes ranging from 70 thru 400 watts. The three distinct sizes ensure correct proportional relationship and architectural DayForm styling that complements most applications.
FloodPak®
Conventional WallPack
FloodPak® @ 0˚
When wall-mounted in the 0° position, the FloodPak® replaces a standard wallpack fixture for use in perimeter and security lighting. The IESNA-rated cutoff optics provide wide distribution with up to 6:1 spacing ratio for maximum distance between fixtures, while meeting stringent Dark Sky requirements. The FloodPak® can also be pole mounted for use in site and area lighting with an optional arm, or it can be rotated 180° for dramatic wall-washing effects.
Wall Wash Indirect
FPS150NLXL-1
FPM175MAL-8
FPL400MAL-8
Full Cutoff Photometry
Site Lighting
Full Cutoff
WATTAGE MULTIPLIER 50 0.25 70 0.4 100 0.59 150 1 MTG HT MULTIPLIER 8 3.5 10 2.3 15 1 20 0.6
Mounting Ht. 15’
Mounting Ht. 15’
Mounting Ht. 15’
FloodPak® Features and Benefits
DayForm AppearanceStylized daytime architectural design.
Rugged ConstructionPrecision die-cast aluminum housing, door frame and mounting box.
Easy AccessHinged door includes clear non-yellowing tempered glass lens.
Multifaceted Reflector Delivers uniform illumination in all positions.
Integral Heat Sink Ensures cool operation and longer ballast life.
Injection Molded Silicon Gasket Triple-finger seal prevents leakage in any position.
Support Cable Permits easy hands-free wiring.
Integral Bubble LevelFast positioning of mounting bracket.
Duraplex-II Polyester Powder Finish Dark bronze standard. Other designer colors available.
Corrosion-Resistant HardwareAll exposed hardware made from stainless steel.
Mounting/Wiring BoxRated for 90°C supply wire.Can be surface mounted over various recess boxes or accept ½” conduit. Also accepts a button photocontrol.
cUL Listed for Wet Locations Approved for above and below horizontal aiming.
Covered under multiple patents
Vandal-ResistantCaptive and tamper-resistant screws.
FloodPak® @ 22.5˚
FPS150NLXL-1
FPM175MAL-8
FPL400MAL-8
Rotating the fixture body to its 22.5° position converts the FloodPak® to semi-cutoff optics with forward-throw distribution resulting in up to 5:1 spacing ratio. When pole mounted at the 22.5° angle, light is directed away from the pole base for greater coverage. It can also be ground mounted for above horizontal aiming and indirect lighting.
Pole Mounted Indirect Lighting
Semi-CutoffSemi-Cutoff Photometry
WATTAGE MULTIPLIER 70 0.36 100 0.57 150 0.7 175 1 MTG HT MULTIPLIER 8 3.5 10 2.3 15 1 20 0.6
Mounting Ht. 15’
Mounting Ht. 15’
Mounting Ht. 15’
FloodPak® @ 45˚
FPS150NLXL-1
FPM175MAL-8
FPL400MAL-8
Rotated in the 45° position, the FloodPak® transforms into an all-purpose flood for general lighting. It produces a NEMA 7 x 6 light distribution pattern for applications requiring a wide-beam pattern. In addition to above and below horizontal surface mounting, the FloodPak® can be pole mounted as a high-angle flood or ground mounted for facade and accent lighting.
Flood Lighting Facade Lighting
FloodFloodPhotometry
WATTAGE MULTIPLIER 250 MH 0.57 250 HPS 0.79 400 HPS 1.39 400 MH 1 MTG HT MULTIPLIER 15 1.78 20 1 25 0.64 30 0.44
Mounting Ht. 15’
Mounting Ht. 15’
Mounting Ht. 15’
Contractor Friendly
Thinking Outside the BoxStonco developed its packaging to be user friendly for fixture selection and ease of installation.
Flexible InstallationThe FloodPak® can be mounted using through-wall wiring or surface-mount ½” conduit.
UL Approved Splice BoxThe isolated mounting box allows the contractor to use 90˚C supply wire.
Stonco is Always on the LevelAn auto leveling device is part of every FloodPak® mounting box. Just rotate the box in position on the wall until level and then anchor securely.
Hands-Free WiringAn integral cable holds the fixture
to the installed mounting box, permitting easy hands-free wiring
and single-person installation.
SpecificationsFloodPak® Configurations
Ordering Logic
Dimensional DataFPS
O˚Down 22.5˚Down 45˚Down 0˚Up 22.5˚Up 45˚Up
FPS 150 NLX L 1
SERIES WATTAGE LAMP SOURCE LAMP VOLTAGE
FPS 42 NLX=High Pressure Sodium (NPF) L= Lamp 1=120 70 HFL=Compact Fluorescent Furnished 100 150 HID units supplied with clear medium base lamp.
FPM 175 MA L 8
SERIES WATTAGE LAMP SOURCE LAMP VOLTAGE
FPM 70 MA=Metal Halide (CWA) L= Lamp 1=120 100 LX=High Pressure Sodium (HX-HPF) Furnished 5=480 150 PMA=Pulse Start Metal Halide (HX-HPF) 8=120/ 208 175 240/277HID units supplied with clear medium base lamp.
FPL 400 MA L 8
SERIES WATTAGE LAMP SOURCE LAMP VOLTAGE
FPL 250 MA=Metal Halide (CWA) L= Lamp 1=120 400* LX=High Pressure Sodium (CWA) Furnished 5=480 8=120/208/Supplied with clear mogul base lamp. 240/277*Requires reduced outer jacketed lamp.
EPA = 0.67 sq. ft. FPM EPA = 0.89 sq. ft.
FPL EPA = 1.68 sq. ft.
FloodPak® Accessories
FPSSHIELDFPMSHIELDFPLSHIELDVandal Shield - Helps protect lens and lamp from breakage.Clear polycarbonate shield snaps in place over glass lens.
2345 Vauxhall RoadUnion, NJ 070831-800-334-2212
www.FloodPak.comwww.stoncolighting.com
FPSKNUCKLE1/2” Adjustable Knuckle (FPS and FPM Series only).
FPSRPA4” Round pole adapter for use with FPSARM.
FPLRPA4” Round pole adapter for use with FPLARM.
FPLKNUCKLEAdjustable 2” Tenon Slipfitter (FPL Series only).
SFPBRO508-10
These mounting accessories are designed to be used with the standard FloodPak® mounting hardware (above) to adapt the luminaire to other mounting applications.
2” Pipe and Concrete Pad ApplicationsPMAS Pipe Adapter for Small and MediumPMAL Pipe Adapter for Large
Retrofit ApplicationsWMAS Wall-Mounting Adapter for Small and Medium
FPLARMShoebox arm-converts FPL Series FloodPak® to pole mount (minimum 4”square pole). Use FPLRPA for mounting FPLARM to a 4” round pole.
FPSARMShoebox arm converts FPS/FPM Series FloodPak® to pole mount (minimum 4” square). FPS and FPM only- use FPSRPA for mounting FPSARM to a 4” round pole.
Photo ControlP110A - External 120V ControlP105A - Button 120v Control
Printed on recycled paperMinimum 10% post-consumer
Printed in U.S.A.