DRAWING WITH AUTOCAD CONFERENCE AND LECTUR ROOMS 1. Drawing a
Rectangular Conference Room, including furniture.
Drawing settings: a. Use a wizard b. Quick Setup c. OK d. Select
Architectural Units e. Set drawing width: 25'x Length:35' (don't
forget the foot mark) f. Set Grid = 12" g. Set Snap = 6" h. Create
the following Layers:
Layer Name Color LineType - Walls white continuous - Furniture
Red continuous
Room dimensions: Inside walls: 15'x20' Walls depth= 5" Use the
ID point command to locate point on your drawing and have the
position of the point displayed in coordinates. Use the ID point
command to locate a point on the drawing. Use the line command to
draw the right side of the door opening, (see figure below). Use
appropriate command to create the left side of the door
opening.
Use Trim to trim the horizontal wall lines between the two 5"
vertical lines that represent the door opening.
- Add a 3' vertical door line to the upper right corner of the
door opening - Use the Arc (Start, Center, End) option to draw the
door swing arc,
counterclockwise. The start of the arc is the top of the door
line, the center is the bottom of the door line, and the end is the
upper left corner of the door opening.
- Change the current layer to Furniture. Use zoom-extents. - Use
the polyline command to draw the credenza (84"long x 24" deep)
centered on the 15" rear wall of the conference room, 2" away
from the wall. Locate an ID point by snapping to the inside upper
left corner of the conference room. Start the polyline @48, -2
(relative coordinates) away from the point. Finish drawing the
credenza.
- Draw the conference table 120 long x 48 wide using the line
command. You can determine the location of the first point by using
the ID point.
Use 2 chamfer distance to bevel the corners of the conference
table. - Draw a rectangle 26 wide by 28 deep using the line command
- Use the fillet command with radius 12 to edit the rectangle to
create the
shape of the chair.
Major AutoCAD commands used to complete this assignment:
- Polyline - Copy - Offset - Divide - Chamfer - ID point -
Fillet - Rotate - Explode - Trim
