FIAT 124 Spider Seletron Throttle Boost Installation

With the ignition off...

1. Remove the driver’s floor mat and then gently pry the two plastic bolt covers from the left of the gas pedal to reveal the 10mm bolts holding the car pedal assembly to the floor.

�

2. Use a 10mm socket to remove the two bolts holding the assembly. Gently lift the assembly out.

3. Disconnect the electrical connection on the back of the gas pedal and plug in the new Throttle Boost plug. Connect the cars gas pedal plug into the Throttle Boost plug.

�

4. Route the wiring under the dash as to not get tangled with feet.

5. Run the controller wire along the edge of the console lip, back to the side of the driver’s seat.

�

6. Position the gas pedal assembly back in place and tighten the two 10mm bolts, taking car to not pinch or kink any wires.

7. Replace the plastic bolt covers and reinstall floor mat.