Upload
donaldwilson4741
View
179
Download
1
Tags:
Embed Size (px)
DESCRIPTION
Operations and installation manual for the Feniex Pegasus and Apollo series Interior Light Bars. Availabe at www.kanoycommunications.com
Citation preview
Pegasus and Apollo Model #: I-0009F, I-0009R
Record Product Serial Number:
INTERIOR LIGHT BARMANUAL V2This instruction manual serves as a guide for the Feniex Pegasus and Apollo interior lightbar series. IMPORTANT! Please read through all provided instructions and any listed warnings in regards to product use.
www.feniex.comwww.feniex.com
Table of Contents
1 Safety Regulations and Warranty
Safety Regulations 3
Warranty 3
Service after Expiration 3
Copyright 3
Feniex Product Copyright 3
2 Pegasus & Apollo Interior Lightbar Instructions
Pegasus/Apollo Interior Lightbar Wiring Diagram 4
To Replace a Pegasus LED Module 6
To Replace an Apollo LED Module 7
Mounting Instructions
Front Mounting 8
Rear Mounting 10
Mounting Bracket Diagram
Split Brackets 12
Full Brackets 13
FAQ 14
Pegasus & Apollo Interior Lightbar | 2
Pegasus & Apollo Interior Lightbar | 3
Safety RegulationsThe following provides all the information necessary to safely operate the previously listed products of Feniex Industries, Inc. Please read this manual thoroughly before installing or operating your new product in order to prevent any damage or injury. Failure to follow the listed instructions in the manual may result in damage to your products or personal injury.
Proper installation of this product requires good knowledge of automotive systems, electronics and procedures.
Please guarantee all vital components of the vehicle are not in danger of being damaged by drilling holes necessary for installation. Check all sides of the mounting surface before drilling any holes into the vehicle.
Do not install this product in any way that interferes with the deployment of the air bag. Doing so may damage the effectiveness of the air bag and can lead to serious personal and vehicle injury. The installer will assume full responsibility of proper installation of the new unit.
Please clean the mounting surface before installation of the unit when using tape, brackets, magnet, Velcro or suction cups.
The product ground wire must be connected directly to the Negative (-) battery post for effective use of the unit. Please follow all wiring guidelines provided to guarantee long lifespan and productivity. Failing to follow these instructions may result in damage to the product.
WarrantyFeniex Industries, Inc. warrants to the original purchaser that the product shall be free from defects in material and workmanship for sixty (60) months from the date of purchase for all LED products. Feniex Industries warranties speakers, sirens and controllers for 24 months;switchesandflashersfor12months.
If a warranty problem occurs, please contact customersupportat1.800.615.8350orvisit the web site at www.Feniex.com. If the product needs to be returned for repair or replacement, call our customer support line to receive a return merchandise authorization number.Operationaltimesarefrom10a.m.to5p.m.centraltime,MondaythroughFriday. Please do not send in product without contactingsupportfirstforaRMAnumber.
Service After ExpirationFeniex Industries will still provide service for all products after expiration of the warranty. For any issues, call the customer support line. In some instances it may be necessary for the product to be shipped, freight prepaid and insured for loss or damage to Feniex headquarters.
Warning! Utilizing non-factory screws and mounting brackets may result in loss of warranty coverage.
CopyrightThis instruction manual and the Feniex products described in this instruction manual may include or describe copyrighted Feniex material. Laws in the United States and other countries preserve for Feniex Industries and its licensors certain exclusive rights for copyrighted material, including the exclusive right to copy, reproduce in any form, distribute and make derivative works of the copyrighted material. Accordingly, any copyrighted material of Feniex and its licensors contained herein or in the Feniex products described in this instruction manual may not be copied, reproduced, distributed, mergedormodifiedinanymannerwithoutthe express written permission of Feniex Industries, Inc.
Feniex Product CopyrightsThe products described in this document are the property of Feniex Industries, Inc. It is furnished by express license agreement only and may be used only in accordance with the terms of such an agreement. Products and documentation are copyrighted materials. Makingunauthorizedcopiesisprohibitedbylaw. No part of the product or documentation may be reproduced, transmitted, transcribed, stored in retrieval system or translated into any language or computer language, in any form or by any means, without prior permission from Feniex Industries, Inc.
Pegasus & Apollo Interior Lightbar | 4
[email protected]|1.800.615.8350
Pegasus & Apollo Interior Lightbar | 5
[email protected]|1.800.615.8350
Figure 1.0
Single Color Pegasus/Apollo: Black Negative 12V (-) Ground
Red Positive 12V (+) Positive
White Takedown Steady
Yellow Flash Mode Changer
Green Takedown Flash
Blue Left Arrow
Gray Right Arrow
Brown Lightbar On
Blue / Gray Center Out
>1FT.
10 AMP FUSE
BATTERY
Pegasus Interior Lightbar
Important Note! Figure 1.1 is are the system specifications for the Dual Color Standard and Dual Color with Flood option.
Figure 1.1
Dual Color Apollo: Black Negative 12V (-) Ground
Red Positive 12V (+) Positive
White Takedown Steady
Yellow Flash Mode Changer
Green Mode Two (on wire)
Blue Left Arrow
Gray Right Arrow
Brown Mode One (on wire)
Blue / Gray Center Out
>1FT.
10 AMP FUSE
BATTERY
Apollo Interior Lightbar
Pegasus & Apollo Interior Lightbar | 6
[email protected]|1.800.615.8350
To Replace a Pegasus LED Module:
Cover
Frame
Screw
Figure 2.0
Figure 2.1
Figure 2.2
LEDModule
L-Bracket
Studs
Figure 2.3 Figure 2.4
Hex nuts
M3x8Screws
Pegasus & Apollo Interior Lightbar | 7
[email protected]|1.800.615.8350
Figure 3.2 Figure 3.3
To Replace an Apollo LED Module:
Frame
Figure 3.0
Figure 3.1
LEDModule
Studs
6-32Hexnut
Pegasus & Apollo Interior Lightbar | 8
[email protected]|1.800.615.8350
Front Mounting Instructions:See illustration for mounting information.
CertificationsCE Certified
SAE J595 Certified
Meets CCR, Title 13 Requirements
RoHs and REACH compliant LEDs
Pegasus SpecificationsVoltage 9-13 VDC
SAE J595Certified
< 5 Amps
Dimensions 0.95H x 37L x 5.5W(Varies based on model)
Tahoe Front SplitModel Shown
Figure 4.0
Figure 4.1
Passenger Side Bracket
CenterBracket
CenterBracket
Driver Side Bracket
Ford F-150 Front FullModel Shown
Figure 4.2
Figure 4.3
PassengerBracket
DriverBracket
Pegasus & Apollo Interior Lightbar | 9
[email protected]|1.800.615.8350
Front Mounting Instructions:See illustration for mounting information.
Figure 5.0
Figure 5.1
Passenger Side Bracket
DriverSide Bracket
CenterBracket
CenterBracket
VisorSplit Pegasus
Visor
CarRoof
Visor Clip
Pegasus & Apollo Interior Lightbar | 10
[email protected]|1.800.615.8350
Rear Mounting Instructions:See illustration for mounting information.
Charger Full RearModel Shown(upside down)
Figure 6.0
Figure 6.1
CertificationsCE Certified
SAE J595 Certified
Meets CCR, Title 13 Requirements
RoHs and REACH compliant LEDs
Pegasus SpecificationsVoltage 9-13 VDC
SAE J595Certified
< 5 Amps
Dimensions 0.95H x 37L x 5.5W
PassengerBracket
DriverBracket
Pegasus & Apollo Interior Lightbar | 11
[email protected]|1.800.615.8350
Rear Mounting Instructions:See illustration for mounting information.
Figure 7.1
Figure 7.0
Rear of vehicle shown
RearDeck
ChildRestraintBracket
PegasusBracket
RearPegasus
Pegasus & Apollo Interior Lightbar | 12
[email protected]|1.800.615.8350
Pegasus Split Front Bracket Information:
Name: Driver Side: Passenger Side: Center:
Chevy Caprice2011 - 2013
x1
x1
x1
x1
x2
Chevy Tahoe 2007 - 2013
x1 x1
x2
Dodge Charger 2006 - 2010
x1 x1x2
Dodge Charger 2011 - 2013
x1 x1x2
Dodge Ram 2006 - 2013
x1 x1x2
Ford Explorer/Int. 2013 - 2014
x1 x1 x1
x1
Ford Taurus/Int. 2011 - 2013
x1 x1 x2
Universal Splitx1
x1
x1
x1
x2
x2
Pegasus Split Rear Bracket Information:
Name: Driver Side: Passenger Side: Center:
Ford Crown Vic 1998 - 2012
x1 x1x2
Warning! Before commencing mounting instructions, connect the provided rubber gasket trim to the flashback shield. Extra length is provided to allow for flexibility in adjustment. Cut off excess trim. The thin gasket connects to the top of the frame, while the thicker gasket connects to the bottom or the flashback shield.
Pegasus & Apollo Interior Lightbar | 13
[email protected]|1.800.615.8350
Pegasus Full Front Bracket Information:
Name: Center Left: Center Right:
Ford Crown Vic1998 - 2012
x1 x1
Ford Expedition2007 - 2013
x1 x1
Ford Explorer* 2002 - 2010
x1 x1
Ford F-1502009 - 2013
x1 x1
Pegasus Full Rear Bracket Information:
Name: Center Left: Center Right:
Chevy Caprice2010 - 2013
x1 x1
Chevy Impala2006 - 2013
x1 x1
Dodge Charger2011 - 2013
x1
x1
x1
x1
Ford Taurus2011 - 2013
x1
x1
x1
x1
*Important Note! The Ford Explorer center left and center right brackets are mirrors of each other.
Pegasus & Apollo Interior Lightbar | 14
[email protected]|1.800.615.8350
FAQ
Pegasus & Apollo Interior Lightbar | 15
[email protected]|1.800.615.8350
Pegasus & Apollo Interior Lightbar | 16
[email protected]|1.800.615.8350