External Control

Overview

by

nion control i/o

25 pin GPIO connector

Serial control port

Serial bridgingvia CobraNet(RS-485)

Ethernet jack

GPIO Dialog BoxesNioNode CAB 4n

Not a selection in Properties, always available on GPIO

Tab

nion GPIO

Up to 16 User ConfigurableLow Voltage/Current GIO

AS..–16 Digital Input Or Output• 0.8 - 2.0VDC TTL Input• 3.3VDC TTL Output•Up To 8 Rotary Encoders

nion GPIO

Up to 16 User ConfigurableLow Voltage/Current GIO

AS..–16 Analog Input• 0 - 24VDC input with 12 Bit Precision• 1k Or 10K Potentiometer

External Or Self Powered (to ground)

nion GPIO

Up to 16 User ConfigurableLow Voltage/Current GIO

AS..• Three Clock Outputs On Select GIO

•One each–Word/Brick/Frame Clock

nion GPIO

PLUSFour High Current Outputs

500mA @ 11.5VDCConfigurable as PWM

AND

ONE SPDT Fault Relay

cab4n GPIO

8 Analog Or Digital I/O4 SPDT Relays1 SPDT Fault Relay

GPIO-25

• DB-25 to Euro-Connectors Break Out• 4” DIN Rail• 3’ Cable

Driving An LED With A Digital Output+12VDC

GPIO Digital Output

1k 1/4W

General Purpose NPN

TransistorGain ≈ 100

Series Resistance As Needed To Protect Transistor & LED

This diagram is for general reference only and should not be used in system design.

Driving A Relay Coil With GPIO

GPIO Digital Output

1k 1/4W

Series Resistance As Needed To Protect Transistor

+12VDC

1N400312 VDC

Relay CoilImax

<100mA

ALWAYS Use A Flyback Diode On A Relay Coil!It Prevents Back EMF From Destroying The Switching Transistor.

General Purpose NPN

TransistorGain ≈ 100

This diagram is for general reference only and should not be used in system design.

Serial Control• Control Protocols

– RS422, RS485, RS232– Standard ASCII Text Strings

• PASHA, X-Net AND RATC2• Control Alias

– Replaces Control Groups– Improved User Interface– Supports Long Alias Names

•Case Sensitive•No Spaces Allowed

PASHA And X-Net Still Use Three Character Alias

Nion Serial Control Port

•DB9 on the rear of the unit.•Unique pinout - be careful.•RS422/485 operation.•Integral 120 ohm terminators.•Use pins 1 & 2 for RS485 (1+, 2-).•Supplies +12VDC @ 500mA

for XControls.

Control Via TCP/IP

•RATC And RATC2–Both Supported–Re-Use Existing Control Systems–RATC Type Must Be Selected During Design (NioNode Properties)

–RATC2 - Improved User Interface•Shorter Commands•Type “h” For Command List

RATC2 Telnet Session

Control Via TCP/IP

NWare Kiosk

NWare Kiosk

CONtrol MANager

•SNMP Functions (Currently not factory

supported)

•Offload Control Duties From NIONs

•Control Third Party Products (Currently not factory supported)

THE ENDBesides, who likes lookingat PowerPoint all day?

Let’s DO something!Even if it’s wrong.