5
Ext Strips PS12 PS11 Threshold Scan (40k trigger x Vth). Black and Blue are strip channels Red and orange are pads channels. In this situation we can put a threshold of 25DAC with a noise less than 0.1% H8 (Test Beam setup) CalPulse & Threshold Scan Results: Chamber shielded on bottom, top and strips fan-out

Ext Strips

  • Upload
    zandra

  • View
    45

  • Download
    0

Embed Size (px)

DESCRIPTION

H8 (Test Beam setup) CalPulse & Threshold Scan Results: Chamber shielded on bottom, top and strips fan-out. Ext Strips. PS12. PS11. Threshold Scan (40k trigger x Vth). Black and Blue are strip channels Red and orange are pads channels. - PowerPoint PPT Presentation

Citation preview

Page 1: Ext Strips

Ext Strips PS12 PS11

Threshold Scan (40k trigger x Vth).Black and Blue are strip channelsRed and orange are pads channels.In this situation we can put a threshold of 25DAC with a noise less than 0.1%

H8 (Test Beam setup) CalPulse & Threshold Scan Results:

Chamber shielded on bottom, top and strips fan-out

Page 2: Ext Strips

TTP(portable USB Test setup) CalPulse Results:Chamber shielded on bottom, top and strips fan-

out

~3.5-6

PS12 Pads

~3.4-4.5

Ext Strips

~3.3-4.8

PS11 Pads

~3.2-4.4

Int Strips

Page 3: Ext Strips

~3.5-6

PS12

~3.4-4.5

Ext STrips

~3.3-4.8

PS11

~3.2-4.4

Int STrips

TTP CalPulse Results:Chamber shielded on bottom, top and strips fan-

out

Page 4: Ext Strips

Main H8(and confirmed byTTP) Measurements and Conclusion

• No MSPL effects on the Noise.

• Shields need on Bottom, Strips Fan-Out, Top. Good results with all the shields connected to the gnd plane.

• Hybrids with AnDig/DigGnd connected less noisy.

Page 5: Ext Strips

Timing Studies:

• We latched the signal from 1 to 4 clock cycles, to catch the slow rising GEM signal, tests revealed the possibility of using more clk cycles without degrading the level of the noise.

• To increase the drift velocity we can replace the induction gap resistor in the H.V. divider. A good value could be 1.2/1.5M.

• In order to have a bigger improvement of the rising time we could use Ar/CO2/CF4 that increase not only the drift velocity but also the number of primary clusters in the drift gap (more effective than changing only the induction field).(We have to be careful because using CF4, the gain of each GEM foil will be reduced.)