23
Excavator X62 Installation

Excavator X62 Installation. This Webinar is LISTEN only Questions will be answered in writing at the end of the Webinar. QUESTIONS?

Embed Size (px)

Citation preview

Excavator X62 Installation

• This Webinar is LISTEN only

Questions will be answered in writing at the end of the

Webinar.

QUESTIONS?

Excavator X62 InstallationWebinar September 18th, 2009

• LS-B10W Laser Receiver Installation

•LS-B10W Verification

•TS-1 SensorsInstallation/Calibration 9-4-09 WebinarVerification 9-11-09 Webinar

Reference Material

7010-0810 7010-0814

LS-B10W Mounting

Where to mount the LS-B10W

Position the stick appropriately LS-B10W vertical

Determine LS-B10W LocationWhere on Stick to prevent damage

LS-B10W Mounting Bracket

LS-B10W Connection

Body Measurements

Graphical display only

Boom Pivot Height

Laser Receiver Measurements

Calibrate

From Bucket Pivot

Calibrate

Left of Pivot Line

Calibrate

Depth to center of stick

Calibrate

Depth to center of stick

Calibrate

LS-B10W Laser Receiver Calibration

TS-1 Calibrated

0.0o House roll

Position LS-B10W vertical

Press Calibrate

LS-B10W Verification

Level String

6’ below laser

6’ Below

LS-B10W Verification

Zero to Laser (laser on detector)

Elevation set point -6’

Verify bucket on string

Move machine and repeat

Wedge Error

Wedge errors or Inconsistent elevation errors:Perform Elevation Accuracy Verification to check machine and sensor calibration

TS-1 Sensor CalibrationImplement length

Depth to Center of Stick

Depth to center of stick:An error in this measurement would create an elevation error when the body of the machine is on a side slope.

Calibrate

Left of Pivot Line

Left of pivot line:An error in this measurement would create an elevation error when the stick is referenced at any angle other than vertical.

Calibrate

From Bucket Pivot

From bucket pivotAn error in this measurement would create an elevation error when the stick was in any position other that horizontal.

Calibrate

LS-B10W Angle Calibration

LS-B10W angle calibration:An error with this calibration would create and elevation error depending on the angle of the sensor when referencing the laser and the distance the laser is away from on-grade.

• Address to download all TU-Live Webinars: ftp://TUlive+topconuniversity.com:[email protected]/

– Recorded Webinar– PP Presentation– Webinar Q & A

• Additional requests for TU staff:

Email: [email protected]

Questions?