Embed Size (px)
Citation preview
A self-paced MultiMedia based Tutorial/CBT on Process Control Advanced Concepts.
Tutorial/CBT:
This interactive course explains the Advanced Concepts of Process Control and Dynamics using Voice, Video, Animation and Graphics.
Introduction• Overview of
Conventional Control• Overview of Advanced
Control• Block Diagrams• Definitions
Process Dynamics• Introduction• Process Characteristics• Linear Systems
PID Controller• Introduction• PID Gap Controller• Variations of PID
Controller• Advanced Options in
PID Controller• Computer Control
Adaptive Control• Introduction• Gain Scheduling• Auto Tuning• Self Tuning Regulator• Model Reference
Adaptive Control
Dead Time Compensation• Introduction• Smith Predictor
Algorithm• Implementation
Feedforward Control• Introduction• Steady State
Feedforward Control• Dynamic Feedforward
Control• Feedforward
Algorithm• Combined
Feedforward and Feedback Control
Non-Interacting Control• Introduction• Interaction Analysis• Decoupler Design
Computed Variable Control • Introduction• Internal Reflux Control
Model Predictive Control• Introduction• Process Model• Model Predictive
Control• Key Parameters• Example
Intelligent Control• Introduction• Neural Network Based• Control• Fuzzy Logic Control
Advanced Process Control Tutorial and Simulation
GSE Systems www.gses.com/EnVision
• Tutorial has a built-in Quiz and comes with a Learning Management System (LMS) called TutAdmin. The LMS allows an instructor to register trainees and monitor their performance and Quiz scores
• Tutorial is available as a Standalone or Web based application
EnVisione-Learning & Universal Simulation
Advanced Process Control Tutorial and SimulationEnVision
Simulation Modules:
Distillation Process Control Modules
• Dead Time Compensation Control• Non-Interacting Control• Internal Reflux Control• Dual Composition Control• Model Predictive Control
Furnace Process Control Modules
• Furnace Combustion Control• Furnace Pass Balance Control
• Simulation comes with a Learning Management System (LMS) called SimAdmin that allows an instructor to register trainees and monitor their performance
• Simulation is available as Standalone (Single or Dual Monitor) and Instructor-Trainee versions
EnVision
EnVision™ is a trademark of GSE Systems, Inc. All other trademarks are the property of their respective owners. The information in this literature is subject to change without notice and is not to be construed as a warranty.
DS.ENV.15.VC 0616
GSE Systems, Inc. 1332 Londontown Boulevard, Suite 200, Sykesville, Maryland 21784 USA
T: +1 410.970.7800T: 800.638.7912 (U.S. only)F: +1 410.970.7997E: [email protected]
