End Seal Kit Installation Instructions
Embed Size (px)
Citation preview
-
8/2/2019 End Seal Kit Installation Instructions
1/2
End Seal KitInstallation instructionsThe end seal kit terminates
and seals self-regulating heat cables.
3101-TT
Kit Contents
Item Description Quantity
A Shrink End Cap 1
B 1 x 1 Mastic Tape 2
A
B
(866) 635-8123
www.thermaltechusa.com
-
8/2/2019 End Seal Kit Installation Instructions
2/2
1. About 3 inchesfrom the cable end,score the circumfer-ence of
the outer
cable jacket.
instruCtions
2. Create a slit fromto the end of thecable.
3. Flex the scoredpoints and removethe outer jacket.
4. Push the braidback toward andover the cable jacket.Trim braid
as de-sired. This braid willbe covered with heat
shrink.
5. Trim the heatercable end, leavingapproximately 1inch below
the outerjacket.
7. Using the mastictape, diaper thecable end.
8. Slide the shrinkend cap over thecable end and overthe
braid.
9. Heat until com-pletely shrunk andadhesive escapes theboot
end.
6. At the cable end,create a V notch.
