2
® LEFT RIGHT FRONT FRONT EMPIRE STATE BUILDING INSTRUCTION GUIDE EMPIRE STATE BUILDING ® www.WinningSolution.com INCLUDED INSIDE • One 3-D puzzle Empire State Building, New York, USA 902 pieces, 42" x 7 3/4 " x 14" • 4 Cardboard Supports HASBRO and its logo and PUZZ-3D are trademarks of Hasbro and are used with permission. © 2013 Hasbro. All Rights Reserved. TM and ® denote U.S. Trademarks. U.S. Patent No.: 5,251,900. Canadian Patent No.: 2,050,969-4. Manufactured and distributed by Winning Solutions, Inc. 66 Summer Street, Manchester, MA 01944. MADE IN CHINA / FABRIQUÉ EN CHINE 23712 AGES 14+ 42" (107 cm)

EMPIRE STATE BUILDING - Winning Solution · A B ASSEMBLY OF CENTER SUPPORT LEFT RIGHT BACK BACK EMPIRE STATE BUILDING Did you know... THE EMPIRE STATE BUILDING... • …Authors:

Embed Size (px)

Citation preview

®

LEFT RIGHT

FRONT FRONT

EMPIRE STATE BUILDINGINSTRUCTION GUIDE

EMPIRE STATE BUILDING ®

www.WinningSolution.com

INCLUDED INSIDE

•One3-DpuzzleEmpire State Building, New York, USA 902 pieces, 42" x 7 3/4" x 14"

•4CardboardSupports

HASBRO and its logo and PUZZ-3D are trademarks of Hasbro and are used with permission. © 2013 Hasbro. All Rights Reserved. TM and ® denote U.S. Trademarks. U.S. Patent No.: 5,251,900. Canadian Patent No.: 2,050,969-4. Manufactured and distributed by Winning Solutions, Inc. 66 Summer Street, Manchester, MA 01944.

MADE IN CHINA / FABRIQUÉ EN CHINE 23712

AGES14+

42"(107cm)

®

A

B

ASSEMBLYOFCENTERSUPPORT

LEFT RIGHT

BACK BACK

EMPIRE STATE BUILDINGDid you know... THEEMPIRESTATEBUILDING...

• Has appeared in several dozen films, most notably, King Kong.

• Was the world’s tallest skyscraper from 1931 to 1972.

• Has a stone and stainless steel tower, which is supported by 60,000 tons of steel.

Assembly instructions for your PUZZ-3D® adventure1.REMOVEANDSETASIDEWASTEPIECES

Pieces with red dots and/or red lines are not to be used in your puzzle. Frequently, puzzle pieces are still attached to red-dot pieces and it’s easy to miss them. Careful: Not all waste pieces have red dots and/or red lines on them. Refer to the list of components. (if applicable) DO NOT THROW AWAY ANY PIECES MARKED WITH RED DOTS AND/OR RED LINES UNTIL YOUR PUZZLE IS COMPLETED!

2.EXAMINETHETYPESOFPUZZLEPIECESJigsaw: These pieces have regular jigsaw cuts and are usually found in the middle of sections of your Puzz–3D®.

3.ASSEMBLETHESECTIONS

Sort pieces according to color and design, then assemble them to form flat sections. In most cases, a finished section will generally have its perimeter made up of square cut pieces. Complete the sections with help from the list of components (if applicable).

4.ASSEMBLETHEPUZZLE

Assemble your puzzle by referring to the list of components (if applicable) and by following the numerical steps.

5.HELPFULHINTS

Handling the puzzle pieces may cause static electricity which could make them cling to your clothing. Keep your puzzle away from infants and pets. Note that the pieces are non-toxic. Intense heat such as radiators and the sun may cause warping and color fading.

ASquare: These pieces have square cuts on one or more sides and are what make your Puzz–3D® three dimensional!

B