Embla SLM version (Stabilizer less)
Main blades325mm carbon main blade.Used for both models.Piano
wire added to prevent weightsflying away during crash.Black carbon
base color with white line
Battery3S1p 2,100-2,500mAH Lipo batterynecessaryMaximum battery
size should be under100mmX35mmX25mm
One piece moldedskid
SLM rotor headAll setup controlled from 3 axis gyro. Lesspower
loss due to no flybar design. It givesenough power for 3D even with
stock motor.Maximum pitch is +/- 16.3 Axis gyro required
TailTail rotor hub is made of alumimumand stainless steel for
more strength.
Belt driveBelt from Japanese manufacturer used.The belt drive
design is as durable andtrustable as any other Hirobo models.
Drive trainGear ratio 1:12.5:4.4Optimal ratio for 3D flight.CNC
main gear, 11,13,14, and 15Tpinion gear will be available as
optionparts
Carbon main frameMain frame made of better carbonmaterials.
Hirobo original main framelayout for maximum 3D performance.
Linkage2 servo direct/single linkage, Aileronservo is push pull
linkage with levers
Stabilizer barHarder material used.
SZM2 rotor head version (With stabilizer)
SZM2 rotor head （Flybar version)Inheriting D3 / SDX design rotor
head. Mixing armattached on blade holder. Just as previous
models,wide range of different setting possible with usingdifferent
setting holes. Maximum pitch +/- 13 to14.
Swash servo3 swash servo necessaryMaximum swash servo size
should be under24mmX12mmX20mm(distance between mounting hole:
27～29.5mm)
Rudder servo1 rudder servo necessaryMaximum rudder servo size
should be under37mmX17mm(distance between mounting hole
:27～43mm)*There is no limit to height of rudder servo.
CONF
IDENT
IAL
