Electrical Test Bay - EN 50191:2001

Erection and Operation of Electrical Test Equipment

Document Ref: ElectricalTestBay-EN50191-2001 - Published by CCs Electrical Testing © CCs Electrical Testing August 2013.

The Electrical Test Bay includes: Sturdy Work Bench Shelf Fluorescent Work Light Electrical Outlets including:

RCD Protected 230V 13A Single Socket RCD Protected 16A 230V 3 pin Commando Socket RCD Protected 32A 230V 3 Pin Commando Sockets 16A 110V 3 Pin Commando Socket (110V TX supply RCD Protected) 32A 110V 3 Pin Commando Socket (110V TX Supply Protected). Non RCD Protected 13A 230V Socket (RED)

Signal Lights [GREEN] - System is Ready for Operation [RED] - Danger System is in operation

The control system supplied via a No Volt Release Circuit incorporates status indicators:

[No Lights] - Control Circuit is Isolated and out of operation [GREEN] - System energised ready fro operation and safe to Enter [GREEN] &[YELLOW] - System Energised, Barrier Interlock and

Emergency Stops Active, Ready to Switch ON [RED] - Start button pressed Do Not enter In Operation

Safety systems include: 1 x Keyed to reset Emergency Isolation Switch 1 x Twist to Reset Emergency Isolation Switch Tensa Barrier with safety interlock

Warning & Safety Signs Rubber Matting for Workbench, Shelves and Floor.

Constructed from moisture resistant MDF board, the panels are modular and can be installed side by side or by adding panels the overall size and altered to suite specific requirements, assembled on site. Fully Fitted & tested. The unit Requires a minimum 40 Amp 230V Supply and up to a 5KVA 110V safety isolating transformer. Starting Size: Width: 1800mm Depth: 1760mm Height: 2000mm

For more information or to discuss your requirements further please contact: CCs Electrical Testing

| email: safety@ccs-electrical-testing.com |telephone: 01827 61810 |

Horizontal Distance between the barrier

and the prohibition zone

Bench Height a = 800mm Barrier Height b = 1240mm Distance to Danger Point = 1120mm Exceeding the required 900mm