Electric wiring kit for towbars / 13-pin / 12 Volt / ISO … · Electric wiring kit for towbars / 13-pin / 12 Volt / ISO 11446 Righ td Unit 503 Queensway Business Park TELFORD TF1

Part No: FR-089-13

1/16

Electric wiring kit for towbars / 13-pin / 12 Volt / ISO 11446

Righ tdUnit 503 Queensway Business ParkTELFORD TF1 7UL UK

SALETE

Revision: 0 / 28.02.2017FR-089-13

Web: www.rightEmail: sales@right


SALETE

Web: wwwEmail: sales@righ

FORD

Kuga 02/13->

Models WITH/ WITHOUT trailer preparation

This electric kit has to be installed by a professional workshop or a suitable qualified person.The installation instructions must have been read and fully understood before the start of any installation. Please contact your wiring kit provider or the hotline shown in the footer should you need assistance!Make sure the vehicle is approved/homologated by the manufacturer to tow a trailer! Also please check that there is a definite compatibility between this vehicle and the electric kit!Following the installation of the electric kit, the fitting instructions should be kept together with the vehicle service document and vehicle handbook. The fitting instructions contain important information relating to the use and function of the towing kit as well as for any diagnostic or activation process, that might have to be repeated in the future (e.g. after the performance of a vehicle software update).All warranty claims will be forfeited if the electric kit or components contained therein are used incorrectly or modified. If a towing socket adaptor has been used to connect to the trailer or bike rack, this must be removed from the trailer socket once the trailer or bike rack has been disconnected.If the trailer or bike rack is not equipped with a rear fog lamp, depending on the towing vehicle type, the correct function of the towing kit cannot be guaranteed. In such cases, a rear fog lamp should be retro fitted.This towing electric kit will not be covered under warranty if any technical or electrical modifications or software updates have been performed by the vehicle manufacturer after the initial commissioning of the kit. That applies especially to modifications or updates which may cause malfunctions in the trailer socket or any other part of the trailer electrical equipment!Depending on the type of trailer module used in this electric kit, diagnostic interrogation with the vehicle’s electrical system may be limited or will not function. The error memory inside the trailer module may not be able to be accessed by vehicle manufacturers diagnostic system.Error logs relating to the trailer electrical equipment, that may be generated in the vehicle manufacturers diagnostic system as a result of a test procedure, may be due to the incorrect installation of the towing electric kit or the false activation of the trailer module.We always recommend whenever possible, the following troubleshooting process:

An analysis of the vehicle’s error memory and possibly clearing of all faults before the start of the installation!

Try disconnecting the trailer module from the towing harness and re-start the fault clearing process!

If in doubt, limit the time for troubleshooting to a max of 0,5 hours and call our Technical Support Team!

Please follow our instructions carefully and always test the towing electrics using a true lighting board or a specifically designed bulb tester. If an LED tester is used, ensure it is equipped with correct load resistors or malfunctions will occur! This instruction is subject to changes and we reserve the right to make changes to design, colour etc. All of the data and illustrations may not be an exact representation but the text contained in this instruction must be observed!

2/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


3x3x

1x

3x

M

3x1x

20 Amp.minifuse

20 Amp. 1x1x

3x

5x*************** -->

Part No: *********

1/**


SALETE

Revision: * / **********RC-MIT001-7 /*******



SALETE


*Optional

Pag. 14

X

M1

U2U1

T

L

G

AC

B

U3U4

40 Amp.

1x

10x

3-12

13-22 + 30-31

28-29 24-27

3/16

SYMBOL EXPLANATION

TOOLS

ATTENTION!

ATTENTION!

Left (58-L) respectivelyRight (58-R) tail light

Stop light (54) / high mounted, third stop light (54)

Turn signal indicator left

Turn signal indicator right

Rear fog light(s)

Reversing light(s)

Trailer / trailer recognition

Permanent current power supply

Ground or Earth (31)

Ground connection battery terminal lug

Permanent power supply / 13pin socket, chamber 9

Charging wire for trailer battery / 13pin socket, chamber 10

+

15+

+

30+

Positive connection battery terminal lug

54 STOP

L

R

Reverse

+30

Fuse / fuse capacity 20 Ampère

Cigarette lighter /accessory socket

Loudspeaker / buzzer

Park Distance Control

Switch / source of function

Connect together

Disconnect

Look at / See further information

Look carefully at selected area

Present / Occupied / OK

Not present / Not occupied / Not OK

Acoustic indication

Attention / important advice

20 Amp.

20 Amp.

12V

In order to avoid mal-functions and damage to the vehicle’s electrical system the earth terminal must be disconnected from the vehicle’s battery before starting work!

Both the trailer module and the vehicle’s control unit for the electrical system can be damaged during workon the data bus connections if the battery is not disconnected!

Please pay attention to the manufacturer’s instructions when disconnecting and reconnecting the vehicle’s battery!

The vehicle's cooling capacity may have to be increased when retrofitting a trailer coupling!You must observe the manufacturer's instructions!!

!Code

3:3

Note: It may be necessaryto check if this vehicle hasa stored radio code beforedisconnecting the battery!

Co

Co

1


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


4/16

2

3


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


5

4

6

1

2

3

7

X

SEAL WITH SILICONE.

T

8

1

3

2

5/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


4

6

5

X

Option 1 Option 2

6/16

7


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


8

10

9

SOCKET CONNECTION

1-8 STOPReverse 10 9

21W21W 21W 42W 3x21W 42W 21W 240W 180W

DIN/ISO 11446

Pmax

YellowColour Blue White Green Brown Red Black Pink Orange Grey White/Black - White/

Red

1/L 2 3/31 4/R 5/58-R 6/54 7/58-L 8 9 10 11 12 13

+

15++

30+L R

12

Pin-outTool

X

X

Option 1

10 mm1

2

G

7/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


11

14

12

1 2 3Option 2

1 2 3Option 2

13

M

M

M

1 2 3

4

8/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


15

17

16

M

Grey2-pin

Green5-pin

Grey2-pin

Green5-pin

+18 20

32 40

21 40

20 Amp.

U1

Red/Blue

20 Amp.minifuse

20 Amp.

Red/Blue

9/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


18

20

19

Grey/Orange

Violet/Orange !CAN-Data Wire

Green5-pin

L

Important! Please note informations

in picture 1!

U2Grey2-pin

40 Amp.40 Amp.

40 Amp.40 Amp.

F26 F26

10/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


23

21

22

LA

C

B

B

B

54 STOP

54 STOP

Blue/Red1 2

3 4

B

54 STOP

Violet/Brown Violet/Brown

+24 27

30 40

28 40

11/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


24

26

C

25

Grey/Orange


A

C

B

Black

Yellow

Cut to length!

12/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


27

28

C


in picture 1!

CAN HIGH

Black

Grey/Orange

CBlack

Grey/Orange

CAN LOW


in picture 1!

C

Violet/Orange

CYellow

Violet/Orange

Yellow

C

1

2

1

2

13/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


29

30

CAN LOW


in picture 1!

C

Violet/OrangeC

Yellow

Violet/Orange

Yellow

C


in picture 1!

CAN HIGH

Black

CBlack

Grey/Orange

Grey/Orange

Grey/Orange


1

2

U3

U4

U2

14/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


32

3140 Amp.

U4

F26

F26

1

2

3

Extension kitUV-003-ZZ3

+

+-15 amp.

15+

PIN 10

PIN 9

+-15 amp.

+30

Optional

15/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


33

36

34

35

! Code3:3

Trailer Simulator for 7- and13-pin Sockets

Optional

Set up trailer operation

FordDiagnose

FordDiagnose

!

L 54 STOPR

Reverse

Perform Offline

• Connect with Ford ETIS System • Enter dealer number• Enter vehicle VIN• Run Network Test (If necessary)• Scroll to ‘Electrical’• Service Functions•

NOTE! See additional control modules

manually for Towbar. This is only possible once FORD technical systems have prepared these additional control units to accept

If error message appears, it relates to access

•PAM•FCDIM

•SODL•SODR

Option 2 ETIS-IDS

Perform Online

• Connect with Ford ETIS System • Enter dealer number• Enter vehicle VIN• Run Network Test (If necessary)• Vehicle Software• Access Changes & Upgrades• • Press Command

NOTE! See additional control modules

manually for Towbar. This is only possible once FORD technical systems have prepared these additional control units to accept

•PAM•FCDIM

•SODL•SODR

Option 1 ETIS-FDRS

16/16


SALETE

Revision: 0 / 28.02.2017FR-089-13



SALETE


37

40

Adapter socket

Optional

38

39

13-pin 7-pin

*************** -->

Part No: *********

1/**


SALETE

Revision: * / **********RC-MIT001-7 /*******



SALETE


!

L R

MENUOK

P 500 miles6666 miles

Driving Aids

6:00 AM 36 F

C H0

1

23 4

56

7

8

RPMx1000

1/210

20

40

6080

100

120

140

160

20

40

60

80100

120 140160

180

200

220

240

260km/h

LED

RL

Documents

Electric wiring kit for towbars / 13-pin / 12 Volt / ISO … · Electric wiring kit for towbars / 13-pin / 12 Volt / ISO 11446 Righ td Unit 503 Queensway Business Park TELFORD TF1