Upload
nestor-mansipe
View
218
Download
0
Embed Size (px)
Citation preview
8/11/2019 Easy OSD v2 manual.pdf
1/2
OSD input and output connection
PIN, Buttons and signal light:
Home record home location, Max RSSI, clear timer, clear distance value
Menu Call system configuration menu
Switch Switch between configuration options
Select Select each Options value
Reset Restart OSD
Signal Light Off : No power; On: connecting GPS; Flash: working good
With 12V output to Camera, 12V input from Video Transmitter. Video transmitter,
OSD and Camera share one single battery (recommend a 3S lipo pack)
Light Weight and compact size:49mm*32mm*9mm
Typical FPV with OSD set up: (Video transmitter and Camera Not included)
1.
Connect Video in from your Camera
2.
Connect Video out to your wireless A/V transmitter
3.
Connect GPS provided
4.
Connect your main power battery to monitor your main power battery voltage;
5.
Connect RSSI to your RC Receiver (Warning: potential dangerous, could damage yourRX. not recommend to do so if you dont understand your RX well)
6.
Connect 12V power (from BEC Provided or other power source) to power up your OSD
Important Notice, if you want your camera share the same power source with OSD, you must
connect the right wire and check if your camera use 12V voltage. Otherwise, your camera could be
damaged
EASY OSD V2Simple wiring, direct link with any Video Transmitter
Easy OSD v2
Video transmitter
8/11/2019 Easy OSD v2 manual.pdf
2/2
Setting and Configuring your OSD:
Press button on Config Panel to enter system configuration
Use Option SW and Select button to configure
Mode 1with longitude and latitude.
Mode 2,
Time
Shown
(GMT-8)
Setting RSSI Min Max value:
1.
On ground power up TX and RX, press set home button, OSD will record RSSI Max;2.
On ground, power off TX, press Menu button, OSD will record RSSI Min value.
3.
Select Save and Exit to save RSSI Min Max value.
Accessory included:
1.
OSD main modules;
2.
GPS;
3.
Wires.
Notes:
1.
GPS first start will take 1 minute. Re-start only 10 second.
2.
Please note that you need to configure your HOME location with each time to get the
right Flight Distance and Home Distance, and Return Course
3.
Time shown is GMT 8, Pacific Time USA.
Specifications:
OSD Volt 8-12V Consumption 0.625W Weight
GPS Volt 3.3V OSD 12.5g