DYNACO Technical Manual

Door Model M2

Copyright 2005 DYNACO USA, Inc. All rights reserved. No part of this work (including attachments and inclusions) may be reproduced or transmitted in any form or by any means, electronic or mechanical, or by any information storage or retrieval system without permission in writing from the publisher.

M2 and M3 are registered trademarks of DYNACO USA, Inc

DYNACO USA, Inc. 3175 Mac Arthur Blvd. Northbrook, IL 60062 USA DYNACO USA, Inc on the World Wide Web: http://www.dynacodoor.com

For assistance, contact your local DYNACO USA, Inc Customer Service representative.

Table of Contents

Table of Contents

October 2005

Issue 1

Title Page

Chapter 1: Before You Begin...................................................................................................................1 1.1. Safety ...............................................................................................................................................1

1.1.1. Hazard Standards ...........................................................................................................1 1.1.2. Installation Precautions ...................................................................................................1 1.1.3. Operation Precautions ....................................................................................................2 1.1.4. Maintenance Precautions................................................................................................2 1.1.5. Electrical Precautions......................................................................................................2

1.2. Installation Tools ..............................................................................................................................3 1.3. Pre-installation Build-out ..................................................................................................................3 1.4. Unpack the Door ..............................................................................................................................4 1.5. M2 Manifest......................................................................................................................................5

Chapter 2: Mechanical Installation..........................................................................................................6 2.1. Introduction.......................................................................................................................................6 2.2. Assemble the Door...........................................................................................................................7 2.3. Mount the Door ................................................................................................................................9 2.4. Install the Curtain ...........................................................................................................................12 2.5. Install the Counterweight................................................................................................................14 2.6. Mount the Control Box and Photo Eyes.........................................................................................16 2.7. Connect Pneumatic Tube...............................................................................................................17

Chapter 3: DYNALOGIX (DY2000) .........................................................................................................19 3.1. Specifications .................................................................................................................................19

3.1.1. Controls .........................................................................................................................19 3.1.2. Messages ......................................................................................................................21

3.2. Electrical Installation ......................................................................................................................22 3.2.1. Make the Primary Connections .....................................................................................23 3.2.2. Make the Encoder Connections ....................................................................................26 3.2.3. Run Wire for Accessories..............................................................................................27 3.2.4. Power the Door .............................................................................................................28

3.3. Final Checks and Verification ........................................................................................................29 3.3.1. Set the Door Limits........................................................................................................29 3.3.2. Verify the Rotation of the Motor ....................................................................................32 3.3.3. Adjust the Photocell Sensitivity .....................................................................................33 3.3.4. Adjust Reversing Edge Detector Sensitivity..................................................................34 3.3.5. Install and Test Activation Accessories.........................................................................35 3.3.6. Set Automatic Timers ....................................................................................................35 3.3.7. Set Close Timer 14........................................................................................................36 3.3.8. Set Close Timer 11 & 12 ...............................................................................................37 3.3.9. Set the Open and Close Run Timers ...........................................................................39 3.3.10. Install Covers.................................................................................................................40

DOC.0002.000 Technical Manual Issue 1 i

Table of Contents

3.3.11. Set Photo-Eye Disable Position.................................................................................... 41

Chapter 4: Chapter 4: DYNALOGIX II (DY 4000)................................................................................. 43 4.1. Specifications................................................................................................................................. 43

4.1.1. Controls......................................................................................................................... 44 4.1.2. Messages...................................................................................................................... 45

4.2. Electrical Installation ...................................................................................................................... 46 4.2.1. Make the Primary Connections..................................................................................... 46 4.2.2. Make the Encoder Connections ................................................................................... 49 4.2.3. Run Wire for Accessories ............................................................................................. 50 4.2.4. Power the Door ............................................................................................................. 51

4.3. Final Checks and Verification ........................................................................................................ 52 4.3.1. Set the Door Limits ....................................................................................................... 52 4.3.2. Install and Test Activation Accessories ........................................................................ 58 4.3.3. Set Automatic Timers ................................................................................................... 59 4.3.4. Set the MC/PB Timer .................................................................................................... 60 4.3.5. Set the AC/LOOP Timer ............................................................................................... 61 4.3.6. Install Covers ................................................................................................................ 62

Chapter 5: Troubleshooting .................................................................................................................. 63 5.1. Troubleshooting Techniques ......................................................................................................... 63 5.2. Symptoms...................................................................................................................................... 63 5.3. LED Reference .............................................................................................................................. 63 5.4. Manual Operation .......................................................................................................................... 64

Appendix A: Optional Door Mounting Techniques ................................................................................ 65 A.1. Mount the Door .............................................................................................................................. 65 A.2. Mounting the Door with a Fore Frame........................................................................................... 65

Appendix B: Radio Frequency Remote Control Installation ................................................................. 67 B.1. Radio-Frequency Remote Control (RXU)..................................................