Heidenhain TNC 155 Heidenhain TNC 155 and TNC 151 The controller can only run one protocol at the time You have to change machineparameters to change protocol. Common ISO protocol (7,2,even,software) M71 515 M218 17701 M219 21285 M220 279 M221 5382 M222 168 M223 0 M224 4 To open parameters, type in password: Schutz wahl = 95148 [Ent] (this controller was in german) Drip-feed in FE mode M71 515 M218 17736 M219 16712 M220 279 M221 5382 M222 168 M223 1 <- drip-feed on M224 4 To start drip-feeding: Type [Satz folge] [Ext] <programnumber> [Start] (program run ) Sida 1
Heidenhain TNC 155 Heidenhain TNC 155 and TNC 151 The controller
can only run one protocol at the time You have to change
machineparameters to change protocol. Common ISO protocol
(7,2,even,software) M71 515 M218 17701 M219 21285 M220 279 M221
5382 M222 168 M223 0 M224 4 To open parameters, type in password:
Schutz wahl = 95148 [Ent] (this controller was in german) Drip-feed
in FE mode M71 515 M218 17736 M219 16712 M220 279 M221 5382 M222
168 M223 1
