7/28/2019 DRIP Calculator
1/4
STEP. 1 YOUR GARDEN DETAILS
Enter the size (m2) of the area that you wish to water with drip
irrigation.
ENTER THE TOTAL M2
THE AREA 100 M2
STEP. 2 WHAT IS THE SOIL TYPE
Select the soil type found in each of the areas that are to be
watered.
WHAT IS THE SOIL TYPE IN YOUR GARDEN SAND/LOAM
SUGGESTED DRIP DISCHARGE RATE 1.6 L/H
SUGGESTED DRIP & DRIPPERLINE SPACING 0.3 M
STEP. 3 AVAILABLE FLOW RATE FROM TAP
From the tap that you wish to run your drip system from conduct
a simple flow test.
Turn the tap on full, place a bucket underneath & time how
long it takes to fill.
TIME IN SECONDS 15 SEC
VOLUME OF BUCKET IN LITRES 10 L
AVAILABLE FLOW RATE (-20%) IN LITRES PER MINUTE 32.0 L/M
STEP.4 DRIP SYSTEM REQUIREMENTS
TOTAL FLOW REQUIRED 29.6 L/M.
NUMBER OF ZONES REQUIRED FOR EACH AREA 1 ZONES
FLOW PER ZONE 29.6 L/M
TIME TO APPLY 10MM OF WATER 34 MIN
APPROX. AMOUNT OF TECHLINE ASTM
REQUIRED 333.3 M
DISCLAIMER - In connection with certain oral and/or written
information ("Information") being presented and/or provided by
Netafim Ltd., 10 Hashalom St., Tel-AvNetafim Australia Pty Ltd.,
213-217 Fitzgerald Rd, Laverton North, Victoria, Australia, and/or
any of their subsid iaries and/or affiliates (together: Netafim)
and as
provision, the following is hereby stated and clarified: All
Information is provided AS IS and without any express or implied
representations or warranties regardi
purpose. The information may not be up to date or fully state
all the relevant facts. Furthermore, by receiving the Information,
the recipient agrees that any usage
at its own risk.Netafim shall not be liable for any consequences
which arise as a result of the use of the Information by the
recipient, including but not limited to lo
reputation or goodwill or any special, punitive, exemplary
damages and/or any other expense, costs and damages whether direct
or indirect and whether reasona
The recipients is specifically prohibited and not allowed to
reproduce, copy, duplicate, manufacture, supply, sell or distribute
all or any part of the Information.
Move the mouse cursor(
) to click on the yellow cells and select/enter data for Steps
1, 2 & 3
TECHLINE ASTM
- D.I.Y. CALCULATOR
