Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Dragon Touch M10X Camera ReplacementThis guide will show you how to replace the camera on your Dragon Touch M10X.
Written By: Joseph Rockcliffe
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7
INTRODUCTION
This guide will allow you to replace the camera in your device should it be broken.
TOOLS:Phillips #0 Screwdriver (1)iFixit Opening Tools (1)Tweezers (1)
PARTS:Replacement Camera (1)
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7
Step 1 — Camera
Remove the two screws from the top of the tablet as shown in the figure using a J0 philips head bit.
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7
Step 2
Use the large plastic opening tool toseparate the back cover from thedevice. Wedge the sharp end of thetool into the crack and use leverageto further separate the back coverfrom the device.
Still holding pressure on the openingtool, slowly and carefully slide thetool along the gap to separate itfurther. You should hear slightsnapping as it comes apart. Workyour way around all sides until thecover is able to be removed.
Step 3
Using your hands and the separating tool, remove the back cover from the device.
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7
Step 4
Using a J0 phillips head bit, removethe single 1 mm screw from the rearfacing lens cover.
Step 5
Using a J0 phillips head bit, removethe single 1mm screw from the frontfacing camera lens cover.
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7
Step 6
Using a plastic opening tool, pry therear facing camera out of itshousing.
Step 7
Using a plastic opening tool, lift upthe latch that attaches the camera'sribbon cable to the device.
Using tweezers, pull out the ribboncable from underneath the latch.
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7
To reassemble your device, follow these instructions in reverse order.
Step 8
Remove the camera strip from thedevice.
Dragon Touch M10X Camera Replacement Draft: 2018-12-26Guide ID: 62140 -
This document was generated on 2019-09-21 06:09:03 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7