DPK TECHOLYSER, GAT NO. 188, BEHIND S.P.AUTO PARTS, JYOTIBA NAGAR, TALWADE, PUNE -412 114

DPK TECHOLYSER

Gas Sampling Probe SP-01

FEATURES

� Rugged & Modular Construction

� Heated and Non-heated versions available

� Easy filter replacement

� Low maintenance

� Stainless Steel enclosure

� Microprocessor based temperature controller

� Settable Low or High temperature contact

� Status & Fault Alarms on Front Display

DPK TECHOLYSER, GAT NO. 188, BEHIND S.P.AUTO PARTS, JYOTIBA NAGAR, TALWADE, PUNE -412 114

GENERAL The Model SP-01 of heated gas sample probe is designed for continuous use with extractive type Sampling Systems even

where the sample contains dust and Aerosols. Water vapor and high dew-point corrosive gases must be kept above the

dew-point to prevent corrosion and sample degradation prior to hot analysis or sample conditioning. The probe is

available in several versions which may be custom configured to meet user's specific requirements. The probe

incorporates a non-corrosive heated, replaceable sintered SS filter element with a filter porosity of 5 microns. The filter

element is mounted in an electrically heated and thermally isolated Stainless steel housing, which is installed in a

Weather protection housing. The temperature regulation is done by a maintenance free, fully electronic Temperature

Controller with under / over temperature alarm. The heated line can be easily connected to the probe by a suitable SS

Bulkhead fitting.

TECHNOLOGY

The complete unit, consisting of the heated filter Head, temperature controller, mounting flange and Probe assembly can

be mounted anywhere horizontally or vertically. The probe can be connected with a Standard 3 inch, 150# flange

directly. The Flange material is stainless steel. When mounted horizontally, the Probe should be inclined at an Angle of

5° to 15° to allow any condensate formed to drain away from the filter head. A broad range of different materials for In-

Situ probe tubes, and large In-Situ – pre Filters make the SP-01 versatile in application.

FEATURES

A temperature alarm contact signalizes fault and over / under Temperature. An over temperature protection avoids

overheating. The filters can be replaced easily without any tools and without disconnecting the heated line.

TECHANICAL DATA

DPK TECHOLYSER, GAT NO. 188, BEHIND S.P.AUTO PARTS, JYOTIBA NAGAR, TALWADE, PUNE -412 114

SPECIFICATIONS

Filter element SS316; pore size 5 µm;

50 x 40 x 135 mm

Operating pressure 50 ... 150 kPa abs.

Mounting flange

Option

3” ANSI flange, SS316, 150 lb

Variations possible.

Mounting angle Recommended 5°-15° inclined to

allow condensate drainage

Sample gas inlet 3/4“ NPT female thread

Sample gas outlet 1/4“ NPT female thread

Test gas connection Optional

Gas wetted parts SS316, Silicon

Temperature adjustment

Option

5 ... 200°C

5 ... 315°C

Factory setting 150° …. 180°C

Ambient temperature -20°C ... +60°C

Power consumption Approx. 300 Watts

Heater element Approx. 250 Watts

Temperature sensor PT100

Power supply

Option

230VAC / 50 Hz or

110VAC / 50 Hz

Junction box Optional

Electrical connection 3C x 2.5 sq. mm

Alarm contact 230VAC, 5 A

Protection class IP65 with junction box

Weight Approx. 11 kg

Dimensions As per variations