DMX Controller SB-DN-512DMX

to Ethernet hub

512ch DMX scene controller

Computer lighting Moving heads Moving heads

to other DMX fixtures

DMX bus

Wiring

Wiring Diagram

3ch 650mA LED driver

connect to other DMX fixture

10-30VDC

DMX bus

DMX bus

DMX status LED

HDL Buspro

Wiring Diagram

Set the DMX start channel

Start channel(range001-512)：e.g., If you use screw driver to set the start channel as 004, then the rest two channels will be ch5 & ch6, so R channel=4, G channel=5, B channel=6.

Special function: mainly for testing whether the device works or not

513 channel B ON514 light G ON515 light R ON516 lights R&G&B ON

3CH 650mA LED Driver

04/21/23

There is a LCD panel and some keys on this module, you can manually check or change the IP via them.

Whenever the IP is changed, the module is needed to be reset. (press the four keys at the same time for several

seconds.) e.g., set the IP as 192.168.10.122, then reset it, after that, change the IP of the laptop as

192.168.10.123 and ping 192.168.10.122, see if it can be pinged successfully.

IP Setting

subnet ID and device ID

Device remark

Generally no need to set it if just DMX512/1990(if use Art-Net or HDL-NET, need to set these parameters.)

Change the ID if needed

Basic Information

Current area

Channels of current area

Area

Area remark

Save

Area Remark

Select an area

Create new area

Channels waiting to be assigned. Add channels to and delete

channels from current area

Channels in current area

Area Setup

Effect property - CANCELED

Make sure that Lower limit ≤ Higher limit ≤ Max limit, setting range: 0% - 100%

Mapping relationship between “HDL channel” and “DMX channel”

Channel remark

Channel

Select Area

Fill in a range to be involved

Scene remark

Scene

Running time: the transit time till the scene reaches the preset brightness.

Mix the levels of channels to create scene

save

Useful option when creating a scene.

Scene Setup

Add sequence

Add Sequence

Current sequenceSteps (scenes) of current sequence

Sequence

Set sequence mode

Set running timesStep (scene) Qty

save

Sequence Setup

Assign a scene to each step

Set running time of each step

save

Sequence Setup

Channel Control

Set 'single on/off' mode, and input the DMX 512 ID(1/104), control type is 'single channel lighting control', parameter1 is for channel number(1-4), paremeter2 is for brightness(0-100).

use button 1 to control channel 1 of DMX512:

Scene Controluse button 2 to control scene 1 of DMX512:

Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sc

ene', parameter1 is for area number, paremeter2 is for scene number.

Sequence Control

Set 'single on/off' mode, and input the DMX512 ID(1/104), control type is 'sequence', parameter1 is for area number, paremeter2 is for sequence number.

use button 3 to control sequence 1 of DMX512: