DIY ROCK ‘N’ ROLL HINGES TECHSHEET...DIY ROCK ‘N’ ROLL HINGES TECHSHEET NB. Please note that...
4
DIY ROCK ‘N’ ROLL HINGES TECH SHEET NB. Please note that whilst every attempt is made to ensure that these instructions are as clear as possible, we cannot be held responsible for misinterpretation of these instructions or for any subsequent accident or damage caused through mis-fitted parts. 0845 1204582 www.justkampers.com • In the seating position • In the bed position U se the measurements shown for the correct fitting of your hinges. make sure that measurement ‘A’ allows for the seat back to be rolled into the bed position. The sized drawings are given as a starting guide. There are many variations in the way the hinge set can be installed to suit the intended usage. Instructions for positioning your rock n roll bed hinges Front of vehicle Note: These measurements are for a guide only but can be altered to suit your particular application. Rear Floor Support 28mm 120mm 216mm A 50mm Seat Panel Front Panel Side Panel Side Panel Side Panel Seat Back
DIY ROCK ‘N’ ROLL HINGES TECHSHEET...DIY ROCK ‘N’ ROLL HINGES TECHSHEET NB. Please note that whilst every attempt is made to ensure that these instructions are as clear as
NB. Please note that whilst every attempt is made to ensure that
these instructions are as clear as possible, we cannot be held
responsible for misinterpretation of these instructions or for any
subsequent accident or damage caused through mis-fitted parts. 0845
1204582 www.justkampers.com
• In the seatingposition
• In the bedposition
Use the measurements shown for thecorrect fitting of your
hinges. makesure that measurement ‘A’ allows forthe seat back to be
rolled into the bedposition.
The sized drawings are given as astarting guide. There are
manyvariations in the way the hinge set canbe installed to suit the
intended usage.
Instructions for positioning your rock n roll bed hinges
Front ofvehicle
Note: These measurementsare for a guide only but canbe altered
to suit yourparticular application.
