Upload
testroote
View
45
Download
6
Embed Size (px)
Citation preview
3-1
3. Disassembly and Reassembly
3. Disassembly and ReassemblyThis section of the service manual describes the disassembly and reassembly procedures for the LE46C750R2W LCD TV.
WARNING: This LCD TV contains electrostatically sensitive devices. Use caution when handling these components.
3-1. Disassembly and Reassembly Cautions: 1. Disconnect the LCD TV from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
Description Picture Description Screws
1. Place the TV face down on cushioned table.Remove 4 screws from the Stand. Remove stand.
6003-001003(M4, L12, Tapping)
3-2
3. Disassembly and Reassembly
Description Picture Description Screws
2. Remove the screws of rear-cover.
6003-001003(M4, L12, Tapping)
6003-000133(M4, L8, MACHINE)
3. Lift up and remove the rear-cover.
* Caution : Becareful when you lift up the rear-cover, its really sharp as Below picture.
* Rear view of 46"
* Rear view of 55"
3-3
3. Disassembly and Reassembly
Description Picture Description Screws
4. Remove the screws of main board.
*Caution : When connect LVDS cable, be careful dont broke locking and check perfectly insert.
6001-002284(M4, L6, Machine)
4-1. Remove the screws of IP board. Remove the IP board.
6001-002284(M4, L6, Machine
6001-002604(M4, L10, Washer)
5. Remove the speakers (R/L).
6. Remove the screws of Stand BKLT. Lift up the Stand BKLT.
6003-001003(M4, L12, Tapping)
6003-000337(M4, L10, Tapping)
3-4
3. Disassembly and Reassembly
Description Picture Description Screws
7. Remove the screw of panel top.
6003-001003(M4, L12, Tapping)
8-1. Front
8-2. Panel
3-5
3. Disassembly and Reassembly
Description Picture Description Screws
9. Remove the screw of wall bracket.
9-1. Remove the Balance Board BKLT.
9-2. Remove the Balance Board.
10. Detach the cable connected to T-con Board. * If it is not perfect connection, may cause vertical noise. So, be careful.
3-6
3. Disassembly and Reassembly
Description Picture Description Screws
10-1. Remove the screws of T-con.
10-2. Remove the T-con Board.
11. Panel.
Reassembly procedures are in the reverse order of disassembly procedures.
3. Disassembly and Reassembly3-1. Disassembly and Reassembly