Dimex Vinyl Edging Installation

Embed Size (px)

Citation preview

  • 8/9/2019 Dimex Vinyl Edging Installation

    1/2

    28305 State Route 7, Marietta, OH 45750P: 800.334.3776 F: 740.374.2700

    www.edgepro.com

    Using a straight edge spade, make a trench along the bed areawhere edging is to be installed. Trench should be approx. 4

    deep, depending on desired finished edging height.

    Slide spike-anchoring adaptors into track system prior toconnecting pieces. Recommended spacing between spikes is 32

    (max.). Use extra adaptors at or near curves or for additionalsupport when holding back heavier types of decorative stone.

    Slide connectors into track system with locking pegs facingtoward pre-drilled holes on each edging piece. Locking pegsshould click into pre-drilled holes on each of the edging pieces,providing a clean, locked joint without overlapping.

    Place edging in the trench with the track groove toward theplanting bed. Installers may find it easier to connect all piecesbefore placing edging in trench.

    Drive spikes vertically, through loops on spike adaptor until spikehead is against the adaptor. Recommended spacing betweenspikes is 32 (maximum). Use extra adaptors at or near curves orfor additional support when holding back heavier types of decorative stone.

    Installation Instructions

    (Using Spikes and Spike Anchoring Adaptors)

    Tightly pack soil around edging and install landscape fabricand ground cover (decorative stone, mulch, etc.) to the top of the edging.

  • 8/9/2019 Dimex Vinyl Edging Installation

    2/2

    28305 State Route 7, Marietta, OH 45750P: 800.334.3776 F: 740.374.2700

    www.edgepro.com

    Using a straight edge spade, make a trench along thebed area where edging is to be installed. Trenchshould be approx. 4 deep, depending on desiredfinished edging height .

    Slide connectors into track system with locking pegsfacing toward pre-drilled holes on each edging piece.Locking pegs should click into pre-drilled holes oneach of the edging pieces, providing a clean, locked

    joint without overlapping.

    Place edging in the trench with the track groovetoward the planting bed. Installers may find it easier

    to connect all pieces before placing edging in trench.

    Pound stakes, flange pointed downward, through thepre-drilled slots at a 45-degree angle. Use extrastakes at curves , spaced evenly throughout.

    Installation Instructions

    (Using Landscape Stakes and Pre-drilled Slots)

    Tightly pack soil around edging and install landscapefabric and ground cover (decorative stone, mulch,etc.) to the top of the edging.