Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
Made in the USA
Product Overview
Pictured at right is the DW-DF-10W thermoelectric power generator. The generator can be placed on the surface of a gas, propane or small rocket stove to generate the electricity to power electronics with its 12V DC automotive adapter or USB charging port.
The generator comes with a self-powered fan to dissipate and circulate heat.When the hot side of the generator exceeds 715 °F (380 °C), the net poweroutput will exceed 10 watts. The generator is designed to operate with a heat source from 570 °F to 842 °F (300 °C to 450 °C).
The unit is small, light-weight, & portable.
TM
Speci�cations
LEDdynamics, Inc.802.728.4533 P802.728.3800 [email protected]
DEVIL WATT
Geometric Characteristics
1. Base plate2. Casing3. Output interface4. Cold sink fan
Part Number DW-DF-10WOutput Power
Output Voltage
Maximum Hot SurfaceTemperature
Dimension Size
Weight
10 Watts
12V DC from automotive poweradapter and 5V DC from a USB port
3.7” (95mm) x 7.8” (200mm)
3.3 lbs (1.5kg)
The DW-DF-10W generator comes with an adapter cable that supplies a 12V DC automotive
power port and a 5 V DC USB charger.
5. Cold side
7. Hot side6. Modules
1
2
3
4
5
67
3.7” (95mm
)
7.8” (200mm
)
DW-DF-10W Camp Stove Thermoelectric Generator
Page 1 of 2
842 °F (450 °C)
©2017 Devil Watt www.devilwatt.com.Speci�cations subject to change without notice. April, 2017 - Rev 120
12V car adapter/5V USB port
Cold side
Hot side
Heat source
Made in the USA
TM
LEDdynamics, Inc.802.728.4533 P802.728.3800 [email protected]
DEVIL WATT
Typical Application
The DW-DF-10W unit can be placed on top of the open �ame of a gas, propane or small rocket stove. Do not let �ames touch the outside of the unit or the cable.
DW-DF-10W Camp Stove Thermoelectric Generator
Page 2 of 2
©2017 Devil Watt www.devilwatt.com.Speci�cations subject to change without notice. April, 2017 - Rev 2.0
Made in the USA
Directions
Place the generator on top of a gas or propane stove burner, and then turn the stove on. Within approximately 2 minutesthe fan will turn on. you begin charging devices. Caution if connecting the load stops or signi�cantly slows the fans, please remove the load as it may be in excess of the generatorpower output capability.
Allow the cooling fan to run for 5 minutes at full speed before
TM
LEDdynamics, Inc.802.728.4533 P802.728.3800 [email protected]
DEVIL WATT DW-DF-10W Camping Stove
Thermoelectric Generator
Page 1 of 1
1. Remove unit and cable from packaging 2. Align and insert connector 3. Turn clockwise until it is secured tightly
4. The cable is now installed and the generatoris ready to use.
5. To disassemble, rotate counter clockwise until loose 6. Remove the connector the unit is now disassembled
1. The units casing will be hot for some time after use. Always wear leather work gloves when picking the unit up by the handles.
2. Make sure the fans start to rotate within 2 minutes after the open �ame heat source is turned on.
3. To remove the unit from the heat source by using the the sliding handles on the top of the generator. Please be sure to wearleather work gloves or equivalent heat shields to extract handles.
4. Make sure the fans are still spinning fast after the load is added. If not, remove the load and try again after increasing the heat.
5. Operating temperature cannot exceed 840 F (450 C).
6. Never allow �ames to climb up the outside of the generator or burn the cable.
o o
Caution
©2017 Devil Watt www.devilwatt.com.Speci�cations subject to change without notice. April, 2017 - Rev 2.0