Detector Paper

The NA61/SHINE experiment: beams and detector system

Roman Planeta – Jagiellonian UniversityRainer Renfordt – Johann Wolfgang Goethe

University

svn co svn+ssh://svn.cern.ch/reps/na61papers/DetectorPaper

and

https://indico.cern.ch/conferenceDisplay.py?confId=198672

Contributions

1 Introduction

2 Beams 2.1 The proton acceleration chain2.2 The ion accelerator chain2.3 H2 beam line2.4 Hadron beams 2.5 Primary and secondary ion beams ( Ilias contr.)

3 Beam detectors and triggers 3.1 Beam counters (some input needed)3.2 A-detector 3.3 BPDs 3.4 Z-detectors 3.5 Trigger system (Sandro)

4 TPC tracking system 4.1 VTPC, MTPC, GAP - TPC 4.2 He beam pipe4.3 Magnets4.4 Gas system and monitoring 4.5 TPC Front End Electronics

Draft version ready

Contributions

5 ToF systems 5.1 ToF-L, ToF-R 5.2 ToF-F

6 PSD 6.1 Calorimeter design 62. The PSD photodetectors6.3 Performance of the PSD calorimeter

7 Targets and other subsystems 7.1 Targets (missing liquid target contribution )7.2 LMPD

8 Data aquisition and detector control systems 8.1 Readout electronics and DAQ 8.2 DCS

9 Summary and outlook

Draft version ready

Comment corresponding to individual figures:

Fig. 3: degrader thickness incorrectFig. 4: remove stat. boxFig. 5: photos of the same format neededFig. 6 : new plots needed, remove stat. boxes, add labels, same lines thickness conventionFig. 7 right: thicker lines and label, remove statistics boxesFig. 8: remove unnecessary elementsFig. 10: labels size for all panels should be similar

Comments corresponding to individual figures:

Fig. 12 right: better quality plot needed, thicker and bigger labels, close frameFig. 15: color points, thicker frame lines and labelsFig.16: photo should be replaced by a drawingFig. 17: two additional panels needed: proton mass resolution versus momentum, same line thicknessFig. 26: thicker lines and labels. Add units to energy deposit on the first layers.Fig. 27: filling should be more transparent for part of elements