www.fisher-price.com

SwingDeluxe Take-Along™

Model Number: 79618

Please keep this instruction sheet, as it contains important information.Adult assembly is required.

Tool needed for battery installation: Phillips Screwdriver.Requires four “C” (LR14) alkaline batteries for operation (not included).

Weight Limit: 17 lbs (7.7 kg).IMPORTANT! The maximum weight limit for this product is 17 lbs. If your child

weighs less than 17 lbs., but is really active and appears to be able to climb out of the swing, immediately discontinue its use.

Occasionally a consumer may experience a problem with one of our products.

If this should happen, please call us toll-free,rather than return this product to the store.

Usually, we can solve the problem over the telephone or send you replacement parts.

Please call Fisher-Price® Consumer Relations,toll-free at 1-800-432-KIDS,

8 AM - 6 PM EST Monday through Friday.Hearing-impaired consumers using TTY/TDD equipment,

please call 1-800-382-7470.

Or, write to:Fisher-Price® Consumer Relations

636 Girard AvenueEast Aurora, New York 14052

• To prevent falls:- Never use with an active child who

may be able to climb out.- Never use on any elevated surface.

• To prevent injury or death from falls orsliding out, always use restraint system.

• Never leave child unattended.

WARNING

Warnings

Consumer Information

2

Parts

Pad with Restraint

Front Tube

Frame with Liner

3

2 Frame Tubes

• Rotate the upper frame tube until it "snaps" into an upright position,as shown.

Assembly

4

IMPORTANT! Before assembly, inspect this product for damagedhardware, loose joints, missing parts or sharp edges. DO NOT use ifany parts are missing or broken. Contact Fisher-Price® for replace-ment parts and instructions if needed. Never substitute parts.

• Position the front tube so that the rubber feet are flat on the surface.• While pressing the button on the lower frame tube, insert it into an end of the

front tube. Continue to insert the lower frame tube into the front tube until youhear a "click".

• While pressing the button on the front tube, insert it into the end of the lowerframe tube. Continue to insert the front tube into the lower frame tube until youhear a "click".

1

2

UpperFrameTube

RubberFeet

Down

Press Button onLower Frame Tube

Press Button onFront Tube

Assembly

3

5

• Position the frame with liner so that the seat is over the front tube.• While pressing the buttons on the upper frame tubes, insert them into the

holes in the underside of the frame with liner.• Continue to insert the upper frame tubes into the frame with liner until you

hear a "click" on both sides.

4

PressButton

on UpperFrameTube

Framewith Liner

• Pull the front tube to be sure it is secure to each lower frame tube.

LowerFrameTubes

PullFrontTube

Seat

Front Tube

Assembly

5

6

UpperFrameTube

UpperFrameTube

• Fit the pad seat back pocket over the seat back and fasten.• Fit the pad seat bottom pocket over the seat bottom and fasten .B

IMPORTANT! Attach the provided pad (with restraint system) tothis product. Never use this product without the provided pad.

6

Pad SeatBack

Pocket

Pad SeatBottomPocket

• Check to be sure the upper frame tubes are secure in the frame with liner.If you can remove the upper frame tubes from the frame with liner, youhave not properly inserted the tubes into the frame. Remove the upperframe tubes from the frame with liner and repeat Assembly step 4.

B

Framewith Liner

7

Assembly

7

Slot

Slot

WaistBelts

Pad

• Pull the edges of the pad up slightly and insert the waist belts onthe liner through the slots in the pad.

Assembly is now complete.

• Open the battery holder.• Insert four "C" (LR14) alkaline batteries as indicated inside the bat-

tery holder.

• Close the battery holder.

• Locate the battery compartment door on the frame.• Loosen the screw in the battery compartment door with a

Phillips screwdriver.• Remove the battery compartment door and the battery holder

from the battery compartment.

Battery Installation

BatteryHolder

8

BatteryCompartment

DoorBatteryHolder

Hint: We recommend using alkaline batteries for longer battery life.

Battery Installation

• Align the ridge on the battery holder with the groove in the battery compartment.

• Slide the battery holder back into the battery compartment.• Replace the battery compartment door and tighten the screw

with a Phillips screwdriver. Do not over-tighten.

BatteryHolder Battery

CompartmentDoor

9

Battery Tips

• Do not mix old and new batteries.• Do not mix different types of batteries: alkaline, standard (carbon-zinc)

or rechargeable (nickel-cadmium).• Remove the batteries during long periods of non-use. Always remove

exhausted batteries from the toy. Battery leakage and corrosion candamage this toy. Dispose of batteries safely.

• Do not dispose of batteries in a fire. The batteries may explode or leak.• Never short circuit the battery terminals.• Non-rechargeable batteries are not to be recharged.• Only batteries of the same or equivalent type as recommended in the

"Battery Installation" instructions are to be used.• If removable rechargeable batteries are used, they are only to be

charged under adult supervision.• Rechargeable batteries are to be removed from the toy before they

are charged.• If you use a battery charger, it should be examined regularly for damage

to the cord, plug, enclosure and other parts. Do not use a damaged bat-tery charger until it has been properly repaired.

10

1.5V x 4"C" (LR14)

SHOWN ACTUAL SIZE

Securing Your Child

WaistBelt

Restraint

WaistBelt

1

11

• Place your child in the seat. Position the restraint between your child’s legs.• Fasten both waist belts to each side of the restraint. Make sure you hear a

"click" on each side.• Check to be sure the restraint is securely attached by pulling it away from

your child. The restraint should remain attached.

• To prevent falls:- Never use with an active child who

may be able to climb out.- Never use on any elevated surface.

• To prevent injury or death from falls orsliding out, always use restraint system.

• Never leave child unattended.

WARNING

Loosen

To tighten the restraint:• Feed the anchored end of the restraint belt up through the

buckle to form a loop .• Pull the free end of the restraint belt .• Repeat this procedure to tighten the other restraint belt.

To loosen the restraint:• Feed the free end of the restraint strap up through the buckle to

form a loop .• Enlarge the loop by pulling on the end of the loop toward

the buckle.• Pull the anchored end of the restraint belt to shorten the free

end of the restraint belt .• Repeat this procedure to loosen the other restraint belt.Note: After adjusting the restraint to fit your child, make sure youpull on it to be sure it is securely fastened.

B

Securing Your Child

B

Anchored End

Free End

2

12

Tighten

AnchoredEnd

Free End

B

B

Starting the Swing

13

Power Dial

• Turn the power dial to any of eight settings.• Give the seat a light push to start the swinging motion. Adjust the swing

power dial to the desired swing motion setting.

• If swinging stops while using a lower setting, try a higher setting. Give theseat a light push to start the swinging motion again.

• Be sure to turn this product off when not in use. Turn the power dial to theoff setting .

IMPORTANT! Before each use, inspect this product for damagedhardware, loose joints, missing parts or sharp edges. DO NOT use ifany parts are missing or broken. Contact Fisher-Price® for replace-ment parts and instructions if needed. Never substitute parts.

Power Dial

Hint: As with most battery-powered swings, a heavier child willreduce the amount of swinging motion on all settings. In mostcases, the low setting works best for a smaller child while the highsetting works best for a larger child.

Lights and Music!

14

• Slide the lights and music switch to: baby activated lights andone song ; sound and lights off ; or parent activatedlights and music .

When baby pulls either toy on the arch, one tune playsalong with twinkling lights.

On this setting, six tunes (approximately 10 minutes) play along with dancing lights.

Turns lights and music off.

• Turn the volume dial to a comfortable listening level.

Volume DialLights andMusic Switch

Baby Activated Parent Activated

Hint: Your baby can enjoy lights and music with or without swinging.

IMPORTANT! The maximum weight limit for this product is 17 lbs. If yourchild weighs less than 17 lbs., but is really active and appears to be able toclimb out of the swing, immediately discontinue its use.

Lights andMusic Switch

Room-to-Room Portability

15

• Make sure your child is properly secured in the swing seat.• With baby facing forward and outward, lift the swing using the handle.• Carefully carry the swing to another room. Be sure to set the swing down

on a non-elevated, flat surface.

• To prevent falls: Never use on anyelevated surface.• To prevent injury or death from fallsor sliding out, always use restraintsystem.

WARNING

Take-Along

16

Seat Bottom

LiftSeatBack Lift Seat

Bottom

• Tip the swing backwards the seat back down.• Unfasten the straps on the seat bottom.• Pull the straps from the loops on the seat bottom.• Press both tabs on the frame at the same time to release the frame base.

Press TabPress Tab

SeatBack

• Lift the seat back and seat bottom together.

1

2

Straps

Take-Along

Lower FrameTube

• Fit the straps on the seat bottom between the upper and lower frametubes, as shown.

• Wrap the straps around the lower frame tubes and fasten the straps.To set the swing back up for use:• Unfasten the straps around the upper and lower frame tubes.• Replace the straps through the loops on the seat bottom and fasten.• Rotate the lower frame tube around until it snaps into place.• Place the swing on a non-elevated, flat surface.

UpperFrameTube

LowerFrameTube

Strap

• Rotate the lower frame tube around to the top of frame, as shown.

3

4

17

• The pad is machine washable. Wash the pad separately in cold water on the gentlecycle. Do not use bleach. Tumble dry separately on low heat and remove promptly.The frame, liner and toys may be wiped clean using a mild cleaning solution and adamp cloth. Do not immerse the frame.

• This product has no consumer serviceable parts. Do not take this product apart.

IMPORTANT! Never use this product without the provided pad. Be sure to re-attach the provided pad (with restraint system) to this product.

Care

18

Pad SeatBack

Pocket

WaistBelts

Pad SeatBottomPocket

To remove the pad:• Push the waist belts back through the slots in the pad.• Unfasten and slide the pad seat back pocket off of the seat back.• Unfasten and slide the pad seat bottom pocket off of the seat bottom.To replace the pad:• Refer to Assembly steps 6 and 7.

One (1) Year Limited Warranty

19

Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York 14052 warrantsthat the Deluxe Take-Along Swing is free from all defects in material andworkmanship when used under normal conditions for a period of one (1)year from the date of purchase.

Should the product fail to perform properly, we will repair or replace it at ouroption, free of charge. Purchaser is responsible for shipping the product toConsumer Relations at the address indicated above and for all associatedfreight and insurance cost. Fisher-Price, Inc. will bear the cost of shipping therepaired or replaced item to you.This warranty is void if the owner repairs ormodifies the product.This warranty excludes any liability other than thatexpressly stated above including but not limited to any incidental or conse-quential damages.

SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDEN-TAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLU-SION MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSOHAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE.

FCC Statement (United States Only)This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one ormore of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.CAUTION: Changes or modifications not expressly approved by the manufac-turer responsible for compliance could void the user's authority to operatethe equipment.

For other countries, outside the United States:Canada: call 1-800-567-7724, or write to:

Mattel Canada Inc, 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.

Great Britain: telephone 01628 500303.

Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121Australia.

Consumer Advisory Service 1300 135 312.

New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. 79618pr-0920

©2001 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. Printed in China