Upload
ranasherdil
View
324
Download
7
Tags:
Embed Size (px)
DESCRIPTION
Deep Sea is very good manual
Citation preview
0
DEEPSEA Configuration and Installation Guide DEEPSEA ELECTRONICS MODULE Installation and monitoring manual for Genset
Prepared by: USAID PDP Infrastructure Team 1
Table of Contents Summary Information: .................................................................................................................................. 2
How to install Deep Sea Electronics PLC Software to monitor Genset? ....................................................... 3
Getting started with DSE Suit ........................................................................................................................ 6
Login Credentials Info? ................................................................................................................................. 8
How to view Power Information’s? .............................................................................................................. 9
How to view Logs? ...................................................................................................................................... 10
How to Start/Stop Remotely? ..................................................................................................................... 10
How to access DSE Installer Setup from NAS? ............................................................................................ 11
Prepared by: USAID PDP Infrastructure Team 2
Summary Information:
Genset IP Address: 10.10.8.33
Genset Manufacturer: Orient
Genset Module: Deep Sea Electronics
Vendor: Interactive Group
Prepared by: USAID PDP Infrastructure Team 3
How to install Deep Sea Electronics PLC Software to monitor Genset? Click the setup file named as ATS Configration-Suit-installer
Now execute Setup and install the software as shown below:
Read the license agreement for the Virtual Serial Port software supplied by Tibbo Technology Inc. Click I
AGREE to continue.
Prepared by: USAID PDP Infrastructure Team 4
Accept the default settings and click NEXT
Accept the default settings and click INSTALL
Prepared by: USAID PDP Infrastructure Team 5
The driver
installs...
Select REBOOT NOW and click FINISH to reboot your computer and complete the installation process.
You cannot use the DSE860/5 connection until the PC has been rebooted.
Prepared by: USAID PDP Infrastructure Team 6
Getting started with DSE Suit Now to desktop shortcut icons named as DSE Configuration Suit and open it.
In the Following Screen, now follow these steps:
Goto
connect via ->
Tibbo Virtual Serial Port
Serial Setting ->
Baud Rate : 9600
Tick Enable 485
Tick x86 Support
After Selecting above options click Read Configuration from a module. It will read configuration from
the module.
Now this is the main screen of DSE Suit
Prepared by: USAID PDP Infrastructure Team 7
On Left pane Click the Scada and it will connect to the generator and shows all the details about
genetaor e.g OIL gauge, Power, Voltages , Current & Event logs etc..
Prepared by: USAID PDP Infrastructure Team 8
This is the Main display of generator and it shows the current status of the generator.
Login Credentials Info? If your software is protected with the password then the screen will ask the password
Username: mepco
Password: mepco
Note: Mepco is a limited user to gain admin access kindly contact
AD (MIS)/Data Center In charge.
Click ok after entering Password to it, go to startup screen then
follow the steps mentioned in getting started with DSE Suit
Prepared by: USAID PDP Infrastructure Team 9
How to view Power Information’s? Power information can be viewed from the
7310 Scada -> generator -> Frequency Voltages and Current
Power information can be viewed from the 7310 Scada -> generator -> Power
Prepared by: USAID PDP Infrastructure Team 10
How to view Logs? Event Logs can be viewed from the
7310 Scada -> Event Logs
It will view all the logs and can be export to excel and pdf files.
How to Start/Stop Remotely? If you want to start generator remotely then click 7310 Scada -> Mimic it will show the main Generator
screen and now using control you start or stop generator remotely.
Prepared by: USAID PDP Infrastructure Team 11
How to access DSE Installer Setup from NAS?
Go to run and enter NAS IP click ok
Double click on shared folder
Double click on Genset Simulator folder
Prepared by: USAID PDP Infrastructure Team 12
Double click on ATS configuration-suite-installer and the suite will start installation.