Upload
thorsharp
View
216
Download
0
Embed Size (px)
Citation preview
7/31/2019 CW 21 Z-453 N--S16G-P Disassembly & Reassembly
1/4
Disassembly & Reassembly
Samsung Electronics 3-1
3. Disassembly&Reassembly
3-1 OverallDisassembly&Reassembly
3-1-1 DisassemblingtheCabinet
Part Name Description Description Photo
Back
Cover
Remove the 9 screws fixing the Back
Cover & Terminal Board. : RH, +, M4,
L15,ZPC(BLK), SWRCH18A
Tap the Back Cover 2 or 3 times and pull
the cover and remove it.
Since there is a danger of injury from
the remaining current and of damaging
the product due to static electricity,
make sure to remove the power
cord and wait for a moment so that
the remaining current is discharged
completely before disassembling theproduct.
7/31/2019 CW 21 Z-453 N--S16G-P Disassembly & Reassembly
2/4
Disassembly & Reassembly
3-2 Samsung Electronics
3-1-2 DisassemblingtheCRTandChassis
Part Name Description Description Photo
Chassis
Holder
Separate the Assy Holder chassis from
the Front Cabinet.
Pull the Holder Chassis while pushing
the catch up.
If you pull it with excessive power, it may
cause damage to the catch or connector.
Therefore, pull it until the catch is out of
the hole.Pull the chassis while pushing the
clip fixing the Front Cabinet and
the Holder Chassis.
Separate the connection cables
connecting the speaker, Side AV Wire
from the Front Cabinet and the Main &
Micom Board.
Since there is a hinge fixing the Wire
Connector and Connector Header, if
the wire is pulled with excessive power,
it may damage the catch or connector.
Therefore, pull it only after pressing the
hinge down completely.
Separate the D-Coil, DY-Cable and
power cord from the Front Cabinet and
Main Board.
Separate the power cord, DY-Cable by
pushing the fixing catch to the side and
pulling the wire up.
Separate the CRT Assy from the CRT.
Separate the TBC wire, GND cables
from the CRT Assy sequentially.
7/31/2019 CW 21 Z-453 N--S16G-P Disassembly & Reassembly
3/4
Disassembly & Reassembly
Samsung Electronics 3-3
Part Name Description Description Photo
Chassis
Holder
Separate the cable connecting the FBT
and CRT from the CRT.
Since a high voltage current resides
inside the CRT, do not to touch the
CRT hole with metal or your body when
separating the cable.
3-1-3 DisassemblingtheCRTAssy
Part Name Description Description Photo
CRT
Assy
Separate the cables connecting the
Main Assy and the CRT Assy.
Separate the wires from the FBT of the
Main Board and the CRT Assy.
To separate thick wire, pull the wires
while pressing the push-type clip at the
connector.
Take care when separating the wires
because pulling the wires by force may
damage the socket. In addition, separate
the wires on a flat and clean surface so
as to prevent scratching of the material
and the PCB.
Pull the wires while
pressing on the fixing clip.
7/31/2019 CW 21 Z-453 N--S16G-P Disassembly & Reassembly
4/4
MEMO
3-4 Samsung Electronics